GE Monogram ZV900, ZV925 owner manual Controls, Display. Shows the fan setting

Controls and Features

Glass Canopy Hood

Controls

NOTE: Avoid using food products that produce flames under the range hood.

1POWER ON/OFF. Press to activate (turn on)/deactivate (turn off) the control buttons. When the buttons are active (turned on), their outer rings will be illuminated. When active (turned on), the hood lights and fan will automatically turn on at their last settings.

NOTES:

•Always deactivate (turn off) the buttons when the hood is not in use.

•If both the LIGHT and FAN are set to OFF, the buttons will automatically deactivate (turn off) after 10 seconds.

2LIGHT DECREASE ON/OFF. Press to turn on and dim the lights. It remembers the last light level used. The buttons allow you to cycle around to the desired setting. (There are four light levels/settings and OFF.)

3LIGHT INCREASE ON/OFF. Press to turn on and brighten the lights. It remembers the last light level used. The buttons allow you to cycle around to the desired setting. (There are four light levels/settings and OFF.)

4Display. Shows the fan setting.

5FAN DECREASE ON/OFF. Press to turn on and decrease fan settings. It remembers the last fan level used. The buttons allow you to cycle around to the desired setting. (Use to set the fan speed to LOW, MED, HIGH, BOOST or OFF.)

6FAN INCREASE ON/OFF. Press to turn on and increase fan settings. It remembers the last fan level used. The buttons allow you to cycle around to the desired setting. (Use to set the fan speed to LOW, MED, HIGH, BOOST or OFF.)

BOOST—Provides five minutes at the maximum fan setting and then automatically sets to HIGH fan.

SENSOR FEATURE—The hood fan will automatically turn on at the MED setting and the display will show AUTO MODE ON if cooking temperatures become too hot. The fan will stay on for a minimum of 3 minutes and will then turn off when temperatures cool to an appropriate level.

	-LIGHT+			-FAN+
1	2	3	4	5	6

1LOCATE ON/OFF SWITCH. Grasp the filter handle, press inward and then pull down. Remove charcoal filter, if present. Reach into the motor compartment and locate the ON/OFF push-button switch on the side of the motor. Press switch to OFF position.

Push-button Switch (vertical view

from inside opening)

6