Care and Cleaning
Stainless Steel Hood
For your safety
Pour votre securité
Before servicing or cleaning unit, switch power off at service panel and lock the service disconnecting means to prevent power from being switched on accidentally. When the service disconnecting means cannot be locked, securely fasten a prominent warning device, such as a tag, to the service panel.
Avant de réparer ou de nettoyer votre appareil, débranchez le courant au niveau du panneau de service et verrouillez les mécanismes de débranchement de service pour éviter tout branchement accidentel au courant. Si vous ne pouvez pas verrouiller les mécanismes
de débranchement de service, attachez soigneusement un avertissement bien visible, comme une étiquette, au panneau de service.
Metal grease filter
Clean filter light
Clean the grease filter after 30 hours of “on” time. A red signal light will alert you when 30 hours has passed.
Remove the grease filters and wash them either by hand or in the dishwasher using
To clean, swish the filters in hot soapy water or wash them in the dishwasher. Do not use abrasive cleansers.
Replace the filters and make sure that they are correctly seated in the filter channels. Adjust as necessary until the red signal light stops blinking.
NOTE: To remove filters, push them back and down using the knob.
Front 
For proper operation, make sure the filters are securely seated into the channels.
Hood surfaces
Do not use a steel wool pad; it will scratch the surface.
To clean the stainless steel surface, use warm sudsy water or a stainless steel cleaner or polish. Always wipe the surface in the direction of the grain. Follow the cleaner instructions for cleaning the stainless steel surface.
To inquire about purchasing stainless steel appliance cleaner or polish, or to find the location of a dealer nearest you, please call our
National Parts Center | 1.800.626.2002 |
ge.com
Light bulbs
To change the light bulbs:
1.Remove the trim ring by turning it counterclockwise.
2.Grasp the bulb on the edges and pull it straight out.
3.Replace with the same size bulb.
These 12 volt, 20 watt halogen bulbs are available at specialty lighting stores. Ask for GE bulb or equivalent:
On some models, the lights
are located on the sides,
on the underside of the hood.
On some models, the lights are located on the front and back, on the underside of the hood.
7
