CHANGING THE IR CHANNEL
Setting The IR Channel
Use the following procedure to set the proper IR channel on the Switcher.
1Press and hold the EQ button for approximately 5 seconds to enter the IR channel selection mode. The currently selected IR channel will by indicated by a flashing blue LED on the Input Indicators (page 5).
2Press the Select button to cycle through each IR channel.
IMPORTANT: The selected IR channel must be the same as the IR channel set on the IR Remote (see page 8). Refer to the table below for setting the IR channel.
3Once the proper IR channel has been selected, press the EQ button to
confirm and exit the IR channel selection mode. The currently selected input source will now be indicated.
IR Channel Table
Input LED | IR Channel |
1 | 0 |
2 | 1 |
3 | 2 |
4 | 3 |
9
