CHECK LIST
1.On the USB•100S send unit, check that the power indicator is GREEN.
2.On the USB•100S send unit, check that the link indicator is GREEN.
3.On the USB•100R receiver unit, check that the power indicator is GREEN.
4.Once all LEDs are illuminated as suggested, the USB•100 is ready to accept a USB peripheral device at the USB port on the USB•100R receiver unit. Follow the installation instructions as if one were installing the device directly into a computer's USB port.
5.On the host computer, check that a general purpose hub is visible in the Control Panel. Once connected, a USB peripheral device causes its host computer to automatically enumerate it. This simply means that the computer must identify the new device, assign it an ID, and ensure that the required software drivers are available for loading when the device is to be used.
6.The USB•100 is not an end device. Consequently, it does not have a software component or driver to be loaded. Some peripheral devices that are to be attached to the USB•100 will have a USB Driver diskette or
8
