Manuals / Generac / Lawn and Garden / Portable Generator

Generac 04675-3 Mounting, Dimensions, Generac Air-cooled 7 kW, 12 kW Drawing No. 0D3739-B

Models: 04674-2 04675-3 04673-2

1 56

Download 56 pages 28.41 Kb

Page 52

Image 52

50 Generac® Power Systems, Inc.

743

[29

308

[12"]

704

[27.7"]

207 [8.14"]

TRANSFER SWITCH

AIR

490.7 [

Ø30.2mm [Ø1.19"]

914mm [ 36.0" ]

MINIMUM OPEN AREA

ALL AROUND UNIT

NTAKE

Generac Air-cooled 7 kW, 12 kW Drawing No. 0D3739-B

Section 8 — Mounting

(IF SUPPLIED)

LIFTING HOLES 4-CORNERS

716 [28

"DO NOT LIFT BY THE ROOF"

604 [23.5"]

1193 [47"]

622 [24.5"]

1232 [48.5"]

LEFT SIDE VIEW	FRONT VIEW
76.2mm	[3.00"]

PEA GRAVEL

MINUMUM

149

[5.9"]

RIGHT SIDE VIEW

1172.3 [46.2"]

3/4" NPT FUEL INLET

GAS PRESSURE OF 11-14"

WATER COLUMN REQUIRED

CABLE ACCESS HOLES. (REMOVE PLUG FOR ACCESS)

260ROUNDING LUG

[10.2"]

REAR VIEW

**ALL DIMENSIONS IN:

MILLIMETERS [INCHES]

and 15 kW Generators

Dimensions

Page 52

Image 52

Generac 04675-3, 04673-2 Mounting, Dimensions, Generac Air-cooled 7 kW, 12 kW Drawing No. 0D3739-B, and 15 kW Generators

Contents

Models 04673-2 6 kW NG, 7 kW LP 04674-2 12 kW NG, 12 kW LP 04675-3 13 kW NG, 15 kW LPThis manual should remain with the unit Installation and Owner’s ManualINTRODUCTION AUTHORIZED DEALER LOCATIONDANGER safety and/or property of othersIntroduction GENERAL HAZARDS DANGERPlease read all hazards carefully Despite the safe design of this generatorELECTRICAL HAZARDS FIRE HAZARDSEXPLOSION HAZARDS ‹ STANDARDS INDEX1.1 UNPACKING/INSPECTION 1.2 PROTECTION SYSTEMS1.3 SYSTEM SET LED DANGER1.4 THE GENERATOR Generac Power Systems, IncFigure 1.1 - 7 kW, Single Cylinder GH-410 Engine Figure 1.2 - 12 kW/15 kW, V-twin GT-990/760 Engine1.5 SPECIFICATIONS ‹ 1.5.1 GENERATOR‹ 1.5.2 ENGINE Section 1 - General Information1.8 RECONFIGURING THE FUEL SYSTEM 1.6 FUEL REQUIREMENTS AND RECOMMENDATIONS1.7 FUEL CONSUMPTION Figure 1.3 - Demand Regulator1.9 LOCATION 1.9.2 TRANSFER SWITCH1.9.1 GENERATOR 1.9.2.1 7 kW, 12 kW and 15 kW Units1.10 BATTERY INSTALLATION 1.11 THE BATTERYFigure 1.5 - Battery Cable Connections Use tools with insulated handles Wear rubber gloves and boots2.2 CHECK TRANSFER SWITCH OPERATION 2.1 BEFORE INITIAL START-UP2.3 ELECTRICAL CHECKS The following procedures are to be observed2.4 GENERATOR TESTS UNDER LOAD 2.5 CHECKING AUTOMATIC OPERATION2.6 ADJUSTING THE REGULATOR NATURAL GAS ONLY 2.7 ENGINE GOVERNOR ADJUSTMENTFigure 2.2 - Placement of Regulator Do not make any unnecessary adjustments2.8 VOLTAGE REGULATOR ADJUSTMENT Figure 2.3 - Single Cylinder Engine Governor AdjustmentFigure 2.5 - V-twin Full Load Speed Adjust Screw Figure 2.4 - V-twin Engine Governor Adjustment3.1 BREAK-IN PROCEDURE 3.3 AUTOMATIC TRANSFER OPERATION3.4 SEQUENCE OF AUTOMATIC OPERATION 3.2 USING THE AUTO/OFF/MANUAL SWITCH FIGURE3.5 MANUAL TRANSFER OPERATION ‹ 3.5.2 TRANSFER BACK TO UTILITY POWER SOURCEFigure 3.2 - Manual Transfer Switch Operation ‹ 3.5.1 TRANSFER TO GENERATOR POWER SOURCE3.6 SETTING THE EXERCISE TIMER 3.7 PROTECTION SYSTEMSFigure 3.3 - Low Oil Pressure and High Temperature Switches Low Oil Switch4.1 FUSE 4.2 CHECKING THE ENGINE OIL LEVEL4.3 CHANGING THE ENGINE OIL Oil Dipstick and Fill4.5 CHANGING THE ENGINE AIR CLEANER 4.4 CHANGING THE OIL FILTEROil Drain Hose Oil Filter Figure 4.6 - 7 kW, Engine Air Cleaner Location4.7 BATTERY MAINTENANCE 4.6 SPARK PLUGSFigure 4.8 - Setting the Spark Plug Gap Use tools with insulated handles Wear rubber gloves and boots4.8 ADJUSTING VALVE CLEARANCE 4.9 COOLING SYSTEMFigure 4.10 - Valve Clearance Adjustment The maximum ambient temperature for the generator is 48.9 C 104 F4.12 OUT OF SERVICE PROCEDURE 4.10 ATTENTION AFTER SUBMERSION4.11 CORROSION PROTECTION ‹ 4.12.2 RETURN TO SERVICE4.13 SERVICE SCHEDULE 5.1 TROUBLESHOOTING GUIDE PROBLEMCAUSE CORRECTIONENGINE WIRING 24 Generac Power Systems, IncSection 6 - Electrical Data Generac Power Systems, Inc Section 6 - Electrical DataCONTROL PANEL BOX CUSTOMERElectrical Schematic - 12 & 15 kW - Drawing No. 0D8501-B 26 Generac Power Systems, IncSection 6 - Electrical Data Generac Air-cooled 7 kW, 12 kW and 15 kW GeneratorsElectrical Schematic - 12 & 15 kW - Drawing No. 0D8501-B Generac Power Systems, IncSection 6 - Electrical Data Generac Air-cooled 7 kW, 12 kW and 15 kW GeneratorsENGINE WIRING 28 Generac Power Systems, IncSection 6 - Electrical Data Generac Power Systems, Inc Section 6 - Electrical DataCONTROL PANEL BOX CUSTOMERElectrical Schematic - 7 kW - Drawing No. 0D9014-C 30 Generac Power Systems, IncSection 6 - Electrical Data Generac Air-cooled 7 kW, 12 kW and 15 kW GeneratorsElectrical Schematic - 7 kW - Drawing No. 0D9014-C Generac Power Systems, IncSection 6 - Electrical Data Generac Air-cooled 7 kW, 12 kW and 15 kW GeneratorsSection 7 - Exploded Views and Parts Lists 32 Generac Power Systems, IncPART NO. QTY. DESCRIPTION Section 7 - Exploded Views and Parts ListsPART NO. QTY. DESCRIPTION Section 7 - Exploded Views and Parts Lists 34 Generac Power Systems, IncGenerac Air-cooled 7 kW, 12 kW and 15 kW Generators Control Panel - Drawing No. 0E7974-GSection 7 - Exploded Views and Parts Lists PART NO. QTYDESCRIPTION PART NO. QTYand Parts Lists 36 Generac Power1310 16B 16ASection 7 - Exploded Views and Parts Lists PART NO. QTYDESCRIPTION PART NO. QTYSection 7 - Exploded Views and Parts Lists 38 Generac Power Systems, IncSection 7 - Exploded Views and Parts Lists ITEM PART NO. QTY. DESCRIPTIONITEM PART NO. QTY. DESCRIPTION SCREW SHOULDER 8MM M6-1.0 X40 Generac Power Systems, Inc Section 7 - Exploded Views and Parts Lists14 20 Section 7 - Exploded Views and Parts Lists DESCRIPTION1.8 FT 1.25 FTSection 7 - Exploded Views and Parts Lists 42 Generac Power Systems, IncGenerac Air-cooled 7 kW, 12 kW and 15 kW Generators 12 kW and 15 kW Generator - Drawing No. 0D3417-JSection 7 - Exploded Views and Parts Lists DESCRIPTION2.6 FT 3 FTSection 7 - Exploded Views and Parts Lists 44 Generac Power Systems, IncSection 7 - Exploded Views and Parts Lists DESCRIPTIONSection 7 - Exploded Views and Parts Lists 46 Generac Power Systems, IncGenerac Air-cooled 7 kW, 12 kW and 15 kW Generators GN410 Engine - Drawing No. 0E9180-B PartSection 7 - Exploded Views and Parts Lists DESCRIPTIONSection 7 - Exploded Views and Parts Lists 48 Generac Power Systems, IncSection 7 - Exploded Views and Parts Lists DESCRIPTIONDimensions 50 Generac Power Systems, IncALL DIMENSIONS IN MILLIMETERS INCHES Section 8 - MountingSection 9 - Notes Generac Power Systems, IncGenerac Air-cooled 7 kW, 12 kW and 15 kW Generators CALIFORNIA EMISSION CONTROL WARRANTY STATEMENT YOUR WARRANTY RIGHTS AND OBLIGATIONSMANUFACTURER’S EMISSION CONTROL SYSTEM WARRANTY COVERAGE PURCHASER’S/OWNER’S WARRANTY RESPONSIBILITIESSection 10 - Warranty EMISSION CONTROL SYSTEM WARRANTYEMISSION RELATED PARTS INCLUDE THE FOLLOWING GENERAC POWER SYSTEMS STANDARD TWO-YEAR LIMITED WARRANTY FOR GENERAC RESIDENTIAL AND LIGHT COMMERCIAL UNITSSection 10 - Warranty WARRANTY SCHEDULE