Generac Portable Products 2,300 PSI High Pressure Washer

• Install the fuel cap and wipe up any spilled gasoline.

Figure 9 — Connect Garden Hose to Water Inlet

 

Connect Hose and Water Supply to Pump

IMPORTANT: You must assemble the nozzle extension to the spray gun and attach all hoses before you start the engine. Starting engine without all hoses connected and water supplied will damage the pump.

•Uncoil high pressure hose and attach quick connect end of hose to the base of the spray gun (Figure 7). Pull down on the collar of the quick connect, slide onto the gun and let go of collar. Tug on hose to be sure of a tight connection.

Figure 7 — Connect High Pressure Hose to Spray Gun

Coupler Collar

Connect High Pressure Hose Here

•Attach the other end of the high pressure hose to the high pressure outlet on the pump (Figure 8). Pull down on the collar of the quick connect, slide onto the pump and let go of collar. Pull on hose to be sure of a tight connection.

Figure 8 — Connect High Pressure Hose to Pump

Connect High Pressure

Hose Here

•Before you connect your garden hose to the water inlet, inspect the inlet screen (Figure 9). Clean the screen if it contains debris, replace if it’s damaged.

DO NOT RUN THE PRESSURE WASHER IF THE SCREEN IS DAMAGED.

•Run water through your garden hose for 30 seconds to clean out any debris. Turn off water.

•Connect the garden hose to the water inlet. Tighten by hand (Figure 9).

Connect Garden

Hose Here

Inspect inlet screen. Do Not use if damaged, clean if dirty.

WARNING! There MUST be at least ten feet of unrestricted garden hose between the pressure washer inlet and any flow shut off device, such as a ‘Y’ shut-off connector or other convenience- type water shut-off valve. Damage to pressure washer resulting from disregarding this warning will not be covered by the warranty.

•Turn ON the water and open valve all the way. The water supply should be minimum 3.2 gallons per minute.

•Squeeze the trigger on the spray gun until you have a steady stream of water. This purges the pump of air and impurities.

CAUTION! Before starting the pressure washer, be sure you are wearing adequate eye protection.

•Attach the adjustable nozzle extension to the spray gun Tighten by hand (Figure 10).

Figure 10 — Connect Nozzle Extension to Spray Gun

Checklist Before Starting Engine

Review the unit’s assembly to confirm you have performed all of the following:

•Make sure the handle and wireform are in place and secure.

•Check for properly tightened hose connections.

7