Generac Portable Products 3,000 PSI High Pressure Washer
Pressure Washer Rinsing
WARNING! Be extremely careful if you must use the pressure washer from a ladder, scaffolding or any other relatively unstable location. Hose water pressure builds as you climb. When you press the trigger, the recoil from the initial spray can be very strong. The high pressure spray could force you to fall if you are too close to the cleaning surface.
After you have applied detergent, scour the surface and rinse it clean as follows:
•Apply safety latch to spray gun.
•Remove the black chemical nozzle from the nozzle extension.
•Select and install the desired high pressure nozzle following the instructions “How to Use the Nozzles” on page 8.
•Release the safety latch on the spray gun.
•Keep the spray gun a safe distance from the area you plan to spray.
•Increase or decrease spray pressure by turning the pressure control knob counterclockwise or clockwise respectively (Figure 12). Use lower pressure to wash items such a as a car or boat. Use higher pressure to strip paint and degrease driveways.
Figure 12 — Pressure Control Knob
Pressure |
Control |
Knob |
•Apply a high pressure spray to a small area and then check the surface for damage. If no damage is found, you can assume it is okay to continue cleaning.
•Start at the top of the area to be rinsed, working down with same overlapping strokes as you used for cleaning.
Automatic Cool Down System
(Thermal Relief)
If you run the engine on your pressure washer for
SPECIFICATIONS
Rated Pressure . . . . . 3,000 PSI
Flow Rate . . . . . . . . . . 3.0 gallons per minute (gpm)
Detergent . . . . . . . . . . Use detergent approved for pressure washers
Water Supply
Temperature . . . . . . . Not to Exceed 140°F
Automatic Cool . . . . Will cycle when water
Down System | reaches |
Pump Oil | SAE 80W90, 9.6 oz (285 mL) |
10
