10000EXL Extended Life Generator
Your generator requires some assembly and is ready for use after it has been properly serviced with the recommended oil and fuel.
If you have any problems with the assembly of your generator, please call the generator helpline at
IMPORTANT: Any attempt to run the unit before it has been serviced with the recommended oil will result in an engine failure.
REMOVE GENERATOR FROM CARTON
•Set the palleted carton on a rigid flat surface.
•Carefully cut bands around the shipping carton.
•Lift carton off the generator.
•Remove all packing material, carton fillers, etc.
•Remove the generator from the shipping pallet.
INSTALL WHEEL KIT
The wheel kit is designed to greatly improve the portability of your generator.
NOTE: Wheel kit is not intended for
You will need a socket wrench with 1/2" or 13mm sockets and a
Refer to Figure 1 and install the wheel kit as follows:
1.Place the generator on a hard flat surface.
2.Stand at the control panel end of the generator and gently tilt the generator up, high enough to place wooden blocks beneath the cradle.This will allow you to add the wheels.
3.Slide the axle through the holes in the brackets provided on the generator cradle.
4.Slide a wheel spacer, wheel and flat washer on one end of the axle. Make sure the air inflation valve is outward. Place the
5.Place one end of the needle nose pliers on the bottom of the axle and the other end of the pliers on top of the
6.Slide the axle through until wheel is tight against bracket.
7.Install the
Figure 1 — Install Wheel Kit
|
| Support Leg | |
| Hex Nut |
| |
Axle |
| Vibration | Flat Washer |
| Mount | ||
Wheel Spacers |
| Lock Washer | |
| 30mm | ||
|
| Cap | 20mm Cap Screw |
| Flat | Screw |
|
Wheel |
| ||
Washer |
| ||
|
| ||
| 4 |
|
|
