INSTALL THE SANDING SLEEVES ONTO THEIR CORRESPONDING SPINDLES
Step 1
For 1/4, 1/2, & 5/8 spindles loosen the screw on the bracket clamp ( 
) at the bottom of the spindle.
Step 2
Slide the sanding sleeve onto the spindle completely.
Note: the sleeve should slide under the bracket clamp as shown.
Step 3 | Step 4 |
Double check that the sleeve is now on the spindle securely by pulling on the sleeve to make sure it does not slide off the spindle.
For the 1 1/2” and 2” spindles slide the sleeve onto the spindle.
TIGHTEN |
LOOSEN |
Step 5
Using the supplied 12 mm wrench tighten the nut on the top of the spindle by turning counter clockwise (reverse thread).
Step 6
Double check that the sleeve is now on the spindle securely by pulling on the sleeve to make sure it does not slide off the rubber drum. If the sleeve slides on the drum, continue tightening the nut (step 5) in 1/2 turn increments as needed.
8
