ACCESSORY STORAGE
SPINDLES | TABLE INSERT PLATES |
Place the drums into their storage space on the right side of the machine.
Store the table insert plates in the storage slots on the left side of the machine.
INSTALLING SPINDLES ON THE MACHINE
Note: Reverse threads are used to attach the spindle to the machine.
Make sure that the switch is in “OFF” position and that the power cord is unplugged.
If installed, remove the table insert to allow better access the spindle seat.
Step 1
Select the desired spindle and while holding the spindle seat in place with a 17 mm wrench, screw the threaded end into the spindle seat counter clockwise (reverse threads) until hand tight.
LOOSEN 
TIGHTEN
Step 2
Using the two 17 mm wrenches tighten the spindle no more than another 1/2 turn.
NOTE: Do not overtighten the spindle in the seat or it may be very difficult to take off later.
BEFORE STARTING THE MACHINE:
•Make sure the spindle is securely installed onto the arbor.
•Make sure that the corresponding table insert is installed. See the accompanying SELECTION GUIDE (page 10) to select the correct INSERT TABLE for the spindle being used.
9
