Genie 2022, 2042, 2024 manual Mounting the Opener, Getting started, Mounting the assembly

MOUNTING THE OPENER:

1.Getting started.

•Position assembled rail on wall next to header bracket (Fig. 2-4).

–Place material on floor under power head to protect from scratching. (A box, stool, or similar device may be needed to clear a torsion spring.)

NOTE: For header bracket pins locate Bag 2 from Box 1.

2.Mounting the assembly.

•Attach rail to header bracket using clevis pin and cotter pin (Fig. 2-5).

•Support power head on step-ladder to prevent interference with header mounted (torsion) spring.

NOTE: Before final attachment to ceiling, insure that assembly is in proper alignment (Fig. 2-4).

NOTE: For nuts, bolts, and lag screws locate Bag 3 from Box 1.

•On finished ceilings, locate ceiling joists or trusses using a stud finder or similar device. Attach angle iron (not provided) to joists or trusses through finish material using (provided) lag screws (Fig. 2-6).

•On unfinished ceilings or open ceilings, straps may attach directly to joists or trusses. Depending on the garage construction, extra framing material (not provided) which may be required should be installed using appropriate construction techniques (Fig. 2-6).

NOTE: Refer to your local building codes for appropriate construction techniques.

• Attach mounting straps (not provided) to ceiling using lag bolts (Fig. 2-6).

• Set height of power head to following

(Fig. 2-6).

a) Rail must clear door at door’s highest point of travel.

b) Rail must be level or at power head end slightly below level.

•Securely tighten power head mounting bolts and nuts.

•Carefully raise and lower door manually. Ensure door does not contact any section of power head or rail.

•Check that rail clamp bolts and nuts are tight.

•DO NOT PLUG OPENER IN YET!

HEADER BRACKET

VIEW

FROM ABOVE (not to scale)

NO NO

YES / SÍ / OUI

FIG. 2-4 Position assembly and align.

COTTER PIN

CLEVIS PIN

(Chain drive

shown)

FIG. 2-5 Rail mounting to header bracket.

ANGLE IRON ON FINISHED CEILING
	DRYWALL
	Attach angle iron to beams
UNFINISHED OR OPEN BEAM
Extra framing
not needed
	Mounting Straps
	(not provided)
	bolts & nuts
	Extra framing
bolts & nuts	NEEDED

FIG. 2-6 Mounting the power head

PN 37026501206 01/27/2012 13