Genie 3627336241 warranty Programming 1 Remote Controls, Accessories

Adjustment 2: Setting Contact Reverse Function

NOTE

Limit Switch and Force Adjustments must be completed before checking the contact reverse function (Figure A-3)..

AOpen garage door using Wall Console..

BLay a 2” x 4” board flat in center of doorway..

CClose door using Wall Console..

DCheck that door stops and reverses within 2 seconds after it contacts board:

•If door does not reverse, decrease

Close Force until door reverses..

•If door still does not reverse, move

CLOSE Limit Switch toward door..

ECheck Safe-T-Beam® System operation:

•	If beam is blocked, door will	2” x 4” board
	not close..	laid flat

Figure A-3Checking Contact Reverse

NOTE

The door must contact the 2” x 4” board before the Carriage activates the Close Limit Switch.. If not, readjust the Close Limit Switch..

Transmitter Compliance Statement

Accessories

C Programming the

Programming 1: Remote Controls

NOTE

•Each Remote Control must be programmed separately..

•The Remote Controls will not cause the door Opener to close the garage door if the Safe-T- Beam® System is malfunctioning..

•When programming the Remote Controls, they must be at least 24” from the Antenna Wire..

•If the red Learn Indicator Light blinks approximately 4 times per second, programming has stopped.. If programming has stopped, repeat the above steps..

•Each Button on a 2 or 3 Button Remote Control is for a different Opener.. You cannot use more than one Button per Remote, per Opener..

•A maximum of seven Remote Controls or Wireless Keypads can be stored into the Receiver at one time.. If a Remote Control becomes lost, or if you want to delete a Remote Control or Wireless Keypad, see “To Erase All Receiver Memory..”

ATo program one Button of a Remote Control (Figure MA-1):

•Locate Learn Button and Learn Indicator Light on back side of Power Head under the Lens (Figure MA-2)..

•Press and release Learn Button.. Red Learn Indicator Light will blink 2 times per second..

•Press Remote Control Button once within 30 seconds.. Red Learn Indicator Light will stay lit..

•Press Remote Control Button again.. Red Learn Indicator Light will go out, indicating that memory is stored..

BProgram each additional Remote using step A above (up to seven remotes)..

WARNING:

A moving garage door may cause serious injury or death..

•Keep people clear of opening while door is moving..

•Do not allow children to play with the Remote Controls..

If the Safety Reverse does not work properly:

•Close the door and disconnect the Opener using the Emergency Release Cord..

•Do not use the door Opener, Remote Controls, or Wireless Keypad..

•Refer to the door and door Opener Owner’s Manuals before attempting any repairs..

8 For Help, call 1-800-35-GENIE or visit www.geniecompany.com