Remote Control Operation
APress Button on Remote Control.. Garage door will move..
BPress Button again.. Garage door will stop:
•The door automatically stops at the end of the open or close cycle..
CPress Button again.. Garage door will reverse..
1 Button Compact Remote | 3 Button Compact Remote | ||
w/Docking Station | w/Docking Station | ||
|
| Figure | Genie Remote Controls |
|
|
|
|
Learn Code Button
Figure
To Erase All Remotes from Power Head Memory
APress and hold Learn Button on Power Head for 10 seconds or until Learn Indicator Light goes out.. Memory is erased:
• Program Transmitter/Receiver again as needed..
To Replace Remote Control Battery
A
•Pop off the back of the transmitter.
–Use coin, pen, screwdriver or any similar device.
–Replace old Battery with new coin type battery.
•Replace back of remote.
Figure
BFOR FLASHLIGHT MODELS
•Pry open battery cover.. (Notch built into cover..)
– Replace old Battery with new AAA battery.
•Snap shut battery cover.
To program a Homelink® or Car2U Device: (This GDO is Homelink® and Car2U compatible)
•Follow the Homelink® or Car2U instructions in your car owner’s manual..
WARNING
Use the Wall Console included with Opener.. Any other wall console can cause the Opener to operate unexpectedly and the light to stop working..
Install Light Bulbs and Lens
Snap Lens Hinges into
slots on back of Motor Cover
| 60 Watts |
|
Lens | maximum | Push in |
| ||
1A |
| Latches |
| to |
close Lens
Figure
Bulbs
AInstall two 60 Watt light bulbs (not included) into Light Sockets (Figure
• Rough service, 130 Volt bulbs are recommended..
BInstall Lens into slots in Motor Cover..
CInstall Genie Emergency Release Kit
DInstallation is now complete..
For Help, call | 9 |