1. Install light bulb(s) into socket(s).
Do Not use short neck bulb(s).
•Use bulb(s) rated for:
–rough service.
–vibration.
–appliances.
•100 watt maximum.
2. Bend two (2) slotted tabs up. This will activate
the ”living hinge”of the lens (Fig. 11-1).
NOTE: The following steps use the screws from the
Blue Parts Bag that were set aside earlier.
3. Start two (2) No. 8 x 3/4”hex head screws into
bottom holes of panel (Fig. 11-2).
•Slide slotted tabs up behind hex head screws.
•Tighten hex head screws.
4. Align lens holes and holes of panel.
•Insert and tighten a No. 8 x 5/8”pan head
screw into each round lens hole and tighten,
NOTE: Screw heads fit completely into recess of
lens tab.
Fig. 11-2
Fig. 11-1
Pan head
screws
Bend tabs up
Slotted tabs
Bend tabs up (2)
Hex head
screws
11...
LIGHT BULB AND LENS INSTALLATION
FOR HELP-1.800.354.3643 OR GENIECOMPANY.COM
26
[10]
[10]
[9]
Hex Head Screw
No. 8 x 3/4”
Pan Head
Phillips Screw
No. 8 x 5/8”