1. Turn remote control upside down (Fig. 10-1)
2. Battery replacement (your remote control is
battery powered).
•Gently pushstraight IN on tab as shown
(Fig. 10-1).
–use ball point pen, coin or small screwdriver.
–battery cover snaps open.
•Install new battery in same position.
–use A23, 12 Volt battery.
3. Attach visor clip to remote control (Fig. 10-2)
•Slide visor clip into back of case until it snaps
into place.
4. Remote control operation
•Point remote control at the garage door and
press the button. Door will move.
•Press remote control button again and door
will stop.
•Press remote control button again and the door
will move the other way. The door automatically
stops at the end of the open or close cycle.
Fig. 10-1
Fig. 10-2
Visor clip
Battery
Battery
cover
+
–
Fig. 9-1
Learn
code
button
Radio
signal
indicator
MORE MORE
LIMIT ADJUSTMENT
CLOSE OPEN
PUSH
LIMITS
TO SET
4
3
2
1
CLASS 2
NEC
NEC
CLASS 2
1
2
3
4
5
6
MORE
FORCE
PUSH
BUTTON
SAFETY
BEAM
LIMIT
SET
OPEN
FORCE
CLOSE
FORCE
RADIO
SIGNAL
LEARN
CODE
COM
DO NOT
PUSH
LIMIT SET
UNLESS
DOOR IS
ATTACHED
NOTE:
USE ONLY WITH
SERIES II CONTROLS
CLOSE
MORE
OPEN
MORE
CLOSE OPEN
LIMIT ADJUSTMENT
U.S. Patent No. 5,243,784
5,221,869
STEALTH
PRO-MAX
•Press and release a remote control button.
–LED on power head stops blinking.
•Press and release same remote button again.
–LED goes out. Remote is now programmed.
2. Program multi-button remote control
•Repeat step 1 (“program one-button remote” for
each button).
NOTE: Each button on a multi-button remote control
is for a different operator.
3. Operate remote control
•Point remote control at door
–Door moves
•Press button again
–Door stops
•Press button again
–Door reverses
NOTE: Door automatically stops at end of open or
close cycle.
4. Erasing all receiver memory
•Press and hold learn code button on
power head
–10 seconds or until light goes out
–Memory is erased
•Program door operator again
•Press remote control button once within
30 seconds
–LED on power head stays lit
•Press remote control button again
–LED on power head goes out and remote
control is programmed
NOTE: If LED blinks approximately 4 times per
second, programming has stopped. If programming
stops, repeat above steps.
Radio
signal
indicator
Learn
code
button
25
10...