Genius 740A azur, Troubleshooting, Technical specifications, There is no power, There is no sound

Models: 740A

1 14
Download 14 pages 6.69 Kb
Page 13
Image 13
Troubleshooting

Troubleshooting

There is no power

Ensure the AC power cord is connected securely.

Ensure the plug is fully inserted into the wall socket and is switched on. Check fuse in the mains plug or adaptor.

There is no sound

Make sure the unit is not in Standby mode.

Check that source component is properly connected.

Check that 'TAPE MON' is not switched on (unless tape input is required). Check that your speakers are properly connected.

If using Speaker B terminals check they are switched on. Make sure unit is not in mute mode.

There is no sound on one channel

Ensure that balance control is in the correct position.

Check speaker connections.

Check interconnects.

There is a loud buzz or hum

Check turntable or tone arm for ground and connection lead fault. Ensure no interconnects are loose or defective.

Ensure that your tape deck/turntable is not too close to the amplifier.

Unable to make or play tape recordings

Check that TAPE MON and TAPE OUT have been connected correctly.

There is weak bass or diffused stereo imaging

Ensure that speakers are not wired out of phase.

Message on display flashing

See section on CAP5 protection system.

The remote handset will not function

Check that the batteries have not expired.

Ensure that nothing is blocking the remote sensor.

Check that the Front Panel IR dip-switch on rear panel is set to ‘On’.

No response from unit when both In and Out Control Bus sockets are connected

Set Control Bus Passthru dip-switch on rear panel to ‘Off’.

 

azur

740A

Technical specifications

 

 

THD (unweighted)

< 0.001% 1 kHz

 

ENGLISH

Power Output

100W RMS into 8 Ohms

 

 

 

150W RMS into 4 Ohms

 

 

 

at 80% of rated power

 

 

 

< 0.01% 20 Hz - 20 kHz

 

 

 

at 80% of rated power

 

 

Frequency Response

10 Hz - 50 kHz +/- 1 dB

 

 

S/N ratio (ref 1W/8 Ohm)

> 96 dB

 

 

Input impedances

Inputs 1-6 47 kOhm

 

 

 

Tape Input 47 kOhm

 

 

Power Amp damping factor

> 110 at 1 kHz

 

 

Max power consumption

750W

 

 

Minimum power consumption

Active (no signal) 45W

 

 

 

Standby 6W

 

 

Bass & Treble controls

Shelving type

 

 

 

Max bass boost/cut

 

 

 

+/- 10 dB at 10 Hz

 

 

 

Max treble boost/cut

 

 

 

+/- 7.5 dB at 20 kHz

 

 

Dimensions (H x W x D)

115 x 430 x 350mm

 

 

 

(4.5 x 16.9 x 13.8”)

 

 

Weight

10.7kg (23.5Lbs)

 

 

Visit www.cambridge-audio.com and register to receive notification of future hardware and software releases.

This guide is designed to make installing and using this product as easy as possible. Information in this document has been carefully checked for accuracy at the time of printing; however, Cambridge Audio's policy is one of continuous improvement, therefore design and specifications are subject to change without prior notice. If you notice any errors please feel free to email us at: support@cambridgeaudio.com

This document contains proprietary information protected by copyright. All rights are reserved. No part of this manual may be reproduced by any mechanical, electronic or other means, in any form, without prior written permission of the manufacturer. All trademarks and registered trademarks are the property of their respective owners.

Incognito and Incognito Ready are trademarks of Cambridge Audio Ltd. All rights reserved.

© Copyright Cambridge Audio Ltd 2007

A-BUS and A-BUS Ready are registered trademarks of LeisureTech Electronics Pty Ltd Australia.

iPod is a registered trademark of Apple Computer, Inc. All rights reserved.

13

Page 13
Image 13
Genius 740A user manual azur, Troubleshooting, Technical specifications, There is no power, There is no sound