GenTran manual Mounting Instructions for Model 6370C Parallel Power Kit, Hardware Included

Mounting Instructions for Model 6370C Parallel Power Kit

For Honda E3000i Generators Only

Thank you for purchasing this Parallel Power Kit. Do not return this product to the store! If any parts are missing or damaged, please contact us toll free at 1-888-GEN-TRAN or visit our website at www.gen-tran.com. This product is intended for use with two Honda EU3000i generators ONLY. Do NOT attempt to parallel two unlike generators! For 125 Volt Use Only.

TOOLS NEEDED FOR ASSEMBLY:

10 mm socket wrench or nut driver 11/32 nut driver

HARDWARE INCLUDED:

(2)8/32 Nylok nuts

(2)M6-35 Standoffs

Configuration of receptacle

50 amps, 125 V

(L6377)

1

2

STEP 1

NEVER connect Parallel Power Kit while generator is running! Using the 10 mm socket wrench, remove the four

(4) cap nuts on the end of the generator, and set aside.

STEP 2

Mount Parallel Power Kit mounting plate on two bottom studs, and reattach bottom two cap nuts loosely.

3

4

STEP 3

Insert two standoffs into the two upper holes, and hand tighten.

STEP 4

Attach support bar with recesses over the standoffs. Reattach the remaining two cap nuts over the standoffs, and hand tighten. Then attach two Nylok nuts onto the studs protruding from the mounting plate to secure the support bar. Tighten all nuts moderately using a tool.