chorus, delay and reverb processors) require that the signal flow out of the send jack on the amplifier, through the unit where it is split into a dry (unaltered) signal and a wet (processed) signal. On the processing unit, you will use the mixed signal output to return the signals (both wet and dry) to the return jack on the amplifier. The ratio between the wet signal and the dry signal is heard as the amount of effects added back to the original signal, which is controlled by the mix knob (also called “balance”) on the effects processor. Set the input sensitivity on the effects processor according to the processor manufacturer’s instructions. The “effects send jack” may also be used as an auxiliary output to drive a direct box, tape deck etc. This output is preequalization, and pre master volume. The “mute switch” will shut this output down when engaged.
Foot Switches — The
Speaker Output Jacks — The
CABINET FEATURES
Construction — Built from domestic and Baltic Birch plywood, the NEOX400 is sold yet lightweight. The porting system also strengthens the side panels. Our unique
Speaker Configuration — The NEOX400 combo is loaded with two of our GNX10250, 8 ohm loudspeakers and GBE 4941 compression bullet tweeter. This combination is ideal for producing the clarity and versatility of the NEOX400 amplifier. Total cabinet impedance is 4 ohms. Use of an additional speaker cabinet is not recommended.
Internal Crossover — The
SPECIFICATIONS
Power rating: 425W @ 4 ohms
Cabinet impedance: 4 ohms
Frequency response: 45 Hz to 18K Hz
Dimensions: 28 1/4” H x 21 1/4” W x 16 1/2” D
Weight: 66 lbs.
GENERAL SAFETY INFORMATION
Power is supplied to the amplifier through an IEC type detachable cord set with a mains connector, fuse holder and internationally rated 115/230 Volts - 50/60 Hz toroidal power transformer. For our international touring players, an external mains line voltage switch is provided, with a fuse size chart printed on the rear of the unit denoting the power supply configuration and fuse size that the unit has been rated for. International IEC type
Common sense (as well as the law) dictates that you do not operate the unit where it will be exposed to moisture or rain, excessive ambient heat (over 115 degrees F / 40 degrees C) or without a properly grounded A.C. power source. Never remove the ground pin from the A.C. power connector.
Ventilation is required to keep this amplifier from overheating. Do not block air flow over