Gianni Industries DG-15 Series specifications Specifications, ‹ Exiting from the program mode

DG-15 series Digital Keypad Entry system

Operation User's Manual

1. Specifications:

‹Operating Voltage: 12 Vdc

‹Current Draw: Average 15mA, Peak 100mA @ 12Vdc

‹Input: request-to-exit, time out reed switch contact

‹Output: Dual relays, N.O./N.C./Com. Output (free voltage contact)

‹Relays Electric Current: 2A MAX @30Vdc ；0.4A @ 120Vac

‹Relay Activation Time:

„Relay 1 time delay setting code「＊30」、Relay 2 setting code「＊31」

„Strike Time: 1~99 seconds（adjustable）

„Strike mode: Access Timer or Latch

‹Memory Volume: 20+1 PIN codes

„Relay 1 is controlled by ＊01~＊20 user slots

„Relay 2 is controlled by ＊21 user slots

‹Operating Temperature: -20~+70℃

‹Ambient Humidity: 5~95% relative humidity non-condensing

‹Factory Master Code: 12345

‹Invalid PIN Lock-out: The system will shut down for 60 seconds while 30 codes of incorrectly Master Codes enrolled or PIN codes attempted（None beeper signal of keypad activations）.

‹EPROM: Non-volatile memory, System will retain all programs and codes after a total loss of power.

‹The indicator signal chart:

	LED signal				Sound signal
Green LED		Power on, stand-by	1	Beep	Effective PIN codes、Any key pressed
Red LED		Relay 1 activated	2	Beeps	Entering 、Exiting from the Program mode
Yellow LED		Relay 2 activated	3	Beeps	Data computing error
			5	Beeps	Master Code reset to Factory （12345）

2.Operation Instruction: ‹ Enter Program Mode:

1.Compose twice the master code (4 digit format press「1234」、5 digit format press 「12345」) → 2 beeps → you are now in the "programming mode".

2.After 60 seconds if you have not entered any codes or data, the system will automatically exit from the programming mode.

‹Exiting from the program mode:

1.Press「#」 to exit from the programming mode.

2.After 30 wrong codes attempts at the master code the lockout facility will operate.

‹Add PIN codes

Enter the Programming mode, Enter the slot position code 「＊01~＊20」→????? Input 5 digit （or 4 digit）PIN codes→ (beep) enrolled Æ（repeat）

Press 「#」 to exit from the programming mode, or program other operating.

Note 1: The codes「0000」,「00000」,「1234」,「12345」or master code are not be used for PIN code.

Note 2: Relay 2 is controlled by ＊21 user slots

‹To Delete a User Code：

Copyright Gianni Industries, Inc. All Rights Reserved.
P-MU-DG15 Ver. C Publish:2008.11.12	Page: 1/ 3