Gianni Industries DG-15 Series ‹ To Program Relocking Timer, ‹ Changing the Master codes

Enter the Programming mode→ Press the slot position code of your choice to delete (example "06") →Press「＊06」→「0000」（or「00000」）→（beep）→delete→ Press「#」 to exit from the programming mode, or programming other operating.

‹To Program Relocking Timer

Enter the Programming mode,

A.Relay 1：Press「＊30」Followed by the number of seconds the relay should open→「05」=5 seconds（01 ~99 = seconds,「00」Sets the relay to latching mode）→（beep）→enrolled → Press 「#」 to exit from the programming mode, or program other operating.

B.Relay 2：Press「＊31」Followed by the number of seconds the relay should open）→「05 =5 seconds (01 ~99 = seconds,「00」Sets the relay to latching mode). →（beep）→enrolled → Press 「#」 to exit from the programming mode, or program other operating.

C.Latching mode: Correct code entered opens the relay, and the relay stays open until the correct code is entered again.

‹Changing the Master codes:

Enter the Programming mode, Enter「＊00」Followed by the new 4 digit （or 5 digit） master code→（beep）→enrolled→Enter 「#」 to exit from the programming mode, or program other operating.

‹Reset to Factory

„ Master Code reset to Factory 「12345」

Insert the jumper RESETÆ 1-2 positionÆ5 audible beepsÆReset successfulÆ Return Insert the jumper to 2-3 position

„Remove all stored information

Insert the jumper RESETÆ 1-2 positionÆ5 audible beepsÆ Master Code reset to Factory 「12345」Æ after 5 secondsÆ5 audible beepsÆ Remove all stored information Æ Return Insert the jumper to 2-3 position.

Note: If you only wish to reset the Master Code to the Factory default, remove the jumper after exactly 5 audible beeps, otherwise all cards / codes will be deleted.

3. Wiring diagram:

Power Supply

Fail-Safe

Locking Device 2

Relay 2

Contact door reed switch This reed switch is used to reset the re-locking time to 0 second when the door is moved.

Push Button Relay 1

4OR5 RESET

System 4 or 5 digit code setting						Master Code resetting to
							Factory Code"12345"
	4 digit	5 digit	4OR5	RESET	Resetting			Normal

Copyright Gianni Industries, Inc. All Rights Reserved.
P-MU-DG15 Ver. C Publish:2008.11.12	Page: 2/ 3