Gianni Industries DG-25 ‹ Changing the Master codes, ‹ Master Code reset to Factory 「12345」

‹Changing the Master codes:

Enter the Programming mode, Enter「＊000」Followed by the new 5 digit master code→（beep）→enrolled→Enter 「#」 to exit from the programming mode, or program other operating.

‹Master Code reset to Factory 「12345」

Insert the jumper P1Æ 1-2 positionÆ5 audible beepsÆReset successfulÆ Return

Insert the jumper to 2-3 position.

5. Wiring diagram:

Power Supply

Fail-Safe

Locking Device 2

Power Supply

Push Button 2

	Master Code
1
2	reset to
3	Factory 「12345」

Fail-Secure

Locking Device 1

	Contact door reed switch
	This reed switch is used
	to reset the re-locking time
	to 0 second when the door
		is moved.
	(Using N.O. contact in case
		of door closed,
Push Button 1	changeover to N.C. When
		door is moved)

Note:

‹The suggested wire gauge is #22~26 AWG.

‹The varistor or diode must be connected across the lock terminal (electromagnet...) operated by the device. The vartistor controls the overload produced by the strike coil (EMP).

‹Egresses switch should be N.O. type.

Copyright Gianni Industries, Inc. All Rights Reserved.
P-MU-DG25 Ver. B Publish:2008.08.01	Page: 3/ 3