2.Note: After 60 seconds if you have not entered any codes or data, the system will automatically exit from the programming mode. After 6 wrong attempts at the master code the lockout facility will operate.
To Enter a User Code： Enter the Programming mode
1.Enter the slot position code 「＊01~＊10」 →????（user code 4 digit）→（beep） →enrolled→ Press # to exit from the programming mode, or program other operating.
2.Note: The codes"0000","1234" or master code are not be used for PIN code.
To Program Relocking Timer（relay）：
Enter the Programming mode
1.Press「＊20」Followed by the number of seconds the relay should open→「05」=5 seconds（01 ~99 = seconds）→（beep）→enrolled → Press 「#」 to exit from the programming mode, or program other operating.
2.Enter「00」Sets the relay to latching mode. (Correct code entered opens the relay, and the relay stays open until the correct code is entered again).
To Delete a User Code：
Enter the Programming mode→ Press the slot position code of your choice to delete (example "06") →Press「＊06」→「0000」→（beep）→delete→Press「#」 to exit from the programming mode, or programming other operating.
To Change the Master codes:
Enter the Programming mode, Enter「＊00」Followed by the new 4 digit master code→ （beep）→enrolled→Enter 「#」 to exit from the programming mode, or program other operating.
4. Wiring diagram:
Power Supply
LOCKING DEVICE |
Diode
Push Button 
Contact door reed switch
This reed switch is used | 12Vdc | |
to reset the | ||
Power | ||
to 0 second when the door is moved. | ||
Supply |
(Using N.O. contact in case of door closed, changeover to N.C. When door is moved)
| Tamper switch | |
| contact output | |
| (free voltage contact) | |
Buzzer | NC NO Com | |
| ||
| Tamper | |
| Switch | |
NO | ||
Com |
| |
NC | ||
P |
| |
B |
| |
REED | ||
REED | ||
+ |
| |
1 | Master Code | |
2 | ||
3 | to Factory | |
Code"1234" | ||
| ||
Note:
The varistor or diode must be connected across the lock terminal (electromagnet...) operated by the device. The vartistor controls the overload produced by the strike coil (EMP).
Copyright Gianni Industries, Inc. All Rights Reserved. |
|
PMUDG5 Ver. A Publish:2004.08.26 | Page: 2/ 2 |
