Enter Program Mode:
1.Compose twice the master code (Factory master is 「12345」)→ (2 beeps), LED: yellow → "programming mode"
2.Attention:
z If the system is not entered any codes or data in 60 seconds, it will exit from the programming mode automatically.
z After 30 wrong codes attempts to enter the master code, the lockout facility will operate for 60 seconds. (Keypad flashes with blue back light)
Exiting from the program mode:
Press「＃」 to exit from the programming mode.
Add PIN codes
Enter the Programming modeÆ Enter the slot position code 「＊001~＊099」Æ (beep)Æ????? (Enter
5 digital PIN codes) Æ (beep) ÆEnrolled.
Please repeat the procedure to set another user PIN code.
Press 「＃」 to exit from the programming mode, or program other operating.
Remarks: The codes「00000」、「1234」、or master code「12345」are not used to be PIN code.
To Set Time delay for Opening door
Enter the Programming modeÆ「＊100」Æ (beep)Æ01~99 ( Pressing 05 represents for 5 seconds)Æ ( 2 beeps)ÆEnrolled.
Press 「＃」 to exit from the programming mode, or program other operating.
Press 00 for the time delay to be “Latch mode”: The first time PIN codes are entered, the relay changes from N.C. to N.O. (Red LED lights up); The second time PIN codes are entered, the relay changes from N.O. to N.C. (Red LED extinguished)
To Delete a User Code
Enter the Programming mode→ Press the slot position code of your choice to delete (e.g. "06") →Press「＊006」→ (beep)Æ「00000」→ (beep) →deleted
Press「#」 to exit from the programming mode, or programming other operating.
Changing the Master codes
Enter the Programming modeÆ Enter「＊000」Æ (beep)ÆPress the 5 digits to be the new master code→（beep）→Enrolled
Press 「#」 to exit from the programming mode, or program other operating.
Master Code reset to default value 「12345」,
Insert the jumper RESETÆ
Remarks: The occupied PIN codes can’t be the master codes.
Copyright © Gianni Industries, Inc. All Rights Reserved. |
|
Page: 3/ 3 |
