Gianni Industries DK100 III. The indicator signal chart & Default：, IV. Wiring Diagram, Audio

III.The indicator signal chart & Default：

	Green LED	Relay activated
	Red LED	Power on, stand-by
LED signal	Yellow LED	Programming mode
	1 Flashing Yellow LED	Key-in Code Confirmed
	Blue LED	Controller Stand-by
	Flashing Blue LED	Controller Locked
	Bi	Key-in, Effective PIN codes
	Bi－ x 2	Entering or Exiting from the Program mode
Audio	Bi－ x 3	Data computing error, other operation
		mistakes
	Bi－ x 5	Master Code reset to default（12345）or
		remove all stored user codes
	Master code	12345 (changeable)
Default value	Time delay of relays	5 seconds
	Time delay of Keypad	5 seconds
	Time delay of programming mode	60 seconds
	Time delay of Invalid PIN Lock-out	12345 (changeable)

IV. Wiring Diagram:

Attention:

‹The varistor or diode must be connected across the lock terminal (electric strike...) operated by the device. The varistor controls the overload produced by the strike coil (EMP)

‹Cutting spare delay time after door closes for anti-passback: Time delay settled in 10 seconds. If the door is closed in 3 seconds, the remaining 7 seconds will be ignored and door locks automatically once the door closes.

V.Operation Instruction:

Copyright © Gianni Industries, Inc. All Rights Reserved.
P-MU-DK100 Ver.B Published on 2007.09.12	Page: 2/ 3