29B | 29D | 29C |
12)Check plunger surface (29B). If plunger pipe is worn out, loosen tension screws (29C) with a 15mm socket and pull off plunger pipe to the front. Clean front surface of plunger (29B) thoroughly. Apply a small drop of locktite to tension screw. Put a new crush washer (29D) onto tension screw. Put a thin coat of glue (Loctite) on the ring (or ceramic plunger side) and tighten screw to 265
Weep Hole
13)Replace complete seal sleeve (35)/seal case (37) assembly into crankcase (1). Make sure that the weep hole points downward. Note: To replace the oil seals (31), you will need to disas- semble the gear end (see instructions below).
6 4 2 7
8 1 3 5
14)Place entire manifold/seal sleeve assembly over the studs and push firmly until seated against the crankcase.
15)Tighten hex nuts (49A) in a crosswise pattern (shown above) to 59
8
