Gigabyte 4500 manual Long 2 short Monitor or display card error

Answer: Gigabyte motherboards will auto-detect the external VGA card after it is plugged in, so you don't need to change any setting manually to disable the onboard VGA.

Question 9: Why cannot I use the IDE 2?

Answer: Please refer to the user manual and check whether you have connected any cable that is not provided with the motherboard package to the USB Over Current pin in the Front USB Panel. If the cable is your own cable, please remove it from this pin and do not connect any of your own cables to it.

Question 10: Sometimes I hear different continuous beeps from computer after system boots up. What do these beeps usually stand for?

Answer: The beep codes below may help you identify the possible computer problems. However, they are only for reference purposes. The situations might differ from case to case.

JAMI BIOS Beep Codes

*Computer gives 1 short beep when system boots successfully. J AWARD BIOS Beep Codes

*Except for beep code 8, these codes are always fatal.	1 short: System boots successfully
1 beep Refresh failure	2 short: CMOS setting error
2 beeps Parity error	1 long 1 short: DRAM or M/B error
3 beeps Base 64K memory failure	1 long 2 short: Monitor or display card error
4 beeps Timer not operational	1 long 3 short: Keyboard error
5 beeps Processor error	1 long 9 short: BIOS ROM error
6 beeps 8042 - gate A20 failure	Continuous long beeps: DRAM error
7 beeps Processor exception interrupt error	Continuous short beeps: Power error
8 beeps Display memory read/write failure
9 beeps ROM checksum error
10 beeps CMOS shutdown register read/write error
11 beeps Cache memory bad

Question 11: How to set in the BIOS in order to bootup from SATA HDDs by either RAID or ATA mode?

Answer: Please set in the BIOS as follow:

1.Advanced BIOS features--> SATA/RAID/SCSI boot order: "SATA"

2.Advanced BIOS features--> First boot device: "SCSI"

3.Integrated Peripherals--> Onboard H/W Serial ATA: "enable"

Then it depends on the SATA mode that you need to set "RAID" to RAID mode or "BASE" to normal ATA mode in the item named Serial ATA function.

Question 12: For the M/B which have RAID function, how to set in the BIOS in order to bootup from IDE3, 4 by either RAID or ATA mode?

Answer:Please set in the BIOS as follow:

1.Advanced BIOS features-->(SATA)/RAID/SCSI boot order: "SATA"

2.Advanced BIOS features--> First boot device: "SCSI"

3.Integrated Peripherals--> Onboard H/W ATA/RAID: "enable"

Then it depends on the RAID mode that you need to set "RAID" to RAID mode or "ATA" to normal ATA mode in the item named RAID controller function.

Question 13: How to set in the BIOS to bootup from the IDE/ SCSI/ RAID card ?

Answer:Please set in the BIOS as follow:

1.Advanced BIOS features-->(SATA)/RAID/SCSI boot order: "SCSI"

2.Advanced BIOS features--> First boot device: "SCSI"

Then it depends on the mode(RAID or ATA) that you need to set in RAID/ SCSI BIOS.

English

- 95 - Appendix