- 19 -Hardware Installation Process
English

10)BATTERY (Battery)

+

CAUTION

vDanger of explosion if battery is incorrectly
replaced.
vReplace only with the same or equivalent
type recommended by the manufacturer.
vDispose of used batteries according to the
manufacturer’s instructions.

9)F_PANEL (2x10 pins connector)

If you want to erase CMOS...
1.Turn OFF the computer and unplug the power cord.
2.Remove the battery, wait for 30 second.
3.Re-install the battery.
4.Plug the power cord and turn ON the computer.
ØPlease connect the power LED, PC speaker, reset switch and power switch etc of your chassis
front panel to the F_PANEL connector according to the pin assignment above.
HD (IDE Hard Disk Active LED)Pin 1: LED anode(+)
(Blue)Pin 2: LED cathode(-)
SPK (Speaker Connector) Pin 1: VCC(+)
(Amber) Pin 2- Pin 3: NC
Pin 4: Data(-)
RES (Reset Switch)Open: Normal Operation
(Green)Close: Reset Hardware System
PW (Soft Power Connector) Open: Normal Operation
(Red)Close: Power On/Off
MSG(Message LED/Power/Pin 1: LED anode(+)
Sleep LED)(Yellow)Pin 2: LED cathode(-)
NC( Purple)NC
NC
HD+ MSG+
2 20
119
PW-
PW+
RES-
SPK-
1
1
RES+
HD-
1
1
MSG-
1