English
IDE Channel 0 Master, Slave
IDE HDD 
IDE Device Setup. You can use one of three methods:
Auto | Allows BIOS to automatically detect IDE devices during POST(default) |
None | Select this if no IDE devices are used and the system will skip the automatic |
| detection step and allow for faster system start up. |
Manual | User can manually input the correct settings |
Access Mode | Use this to set the access mode for the hard drive. The four options are: |
| CHS/LBA/Large/Auto(default:Auto) |
IDE Channel 2/3 Master, Slave
IDE HDD 
Extended IDE Drive SATA devices setup. You can use one of two methods:
Auto | Allows BIOS to automatically detect SATA IDE devices during POST. |
| (Default value) |
None | Select this if no SATA IDE devices are used and the system will skip the |
| automatic detection step and allow for faster system start up. |
Access Mode | Use this to set the access mode for the hard drive. The two options are: |
| Large/Auto(default:Auto) |
Capacity | Capacity of currently installed hard disk. |
Hard drive information should be labeled on the outside drive casing. Enter the appropriate option based on this information.
Cylinder | Number of cylinders |
Head | Number of heads |
Precomp | Write precomp |
Landing Zone | Landing zone |
Sector | Number of sectors |
Drive A / Drive B
The category identifies the types of floppy disk drive A or drive B that has been installed in the computer.
None
360K, 5.25" 
1.2M, 5.25"
720K, 3.5"
1.44M, 3.5" 
2.88M, 3.5"
Floppy 3 Mode Support (for Japan Area)
Disabled | Normal Floppy Drive. (Default value) | |
Drive A | Drive A is 3 | mode Floppy Drive. |
Drive B | Drive B is 3 | mode Floppy Drive. |
Both | Drive A & B are 3 mode Floppy Drives. | |
- 32 - |
