INSTALLATIONINSIRUCTIONS
Removing packaging materials
• Remove tape and glue residue from surfaces before turning
on the freezer. Rub a small amount of liquid dish soap over
the adhesive with your fingers. Wipe with warm water and
dry.
Do not use sharp instruments, rubbing alcohol, flammable
fluids, or abrasive cleaners to remove tape or glue. These
products can damage the surface of your freezer. For more
information, see the "Freezer Safety" section.
When Moving Your Freezer:
Your freezer is heavy, When moving the freezer for
cleaning or service, be sure to protect the floor, Always pult
the freezer straight out when moving it. Do not wiggle or
"wa!k" the freezer when trying to move it, asfloor damage
couid occur.
Cleaning before use
After you remove all of the packaging materials, clean the inside
of your freezer before using it. See the cleaning instructions in the
"Freezer Care" section.
NOTE: Do not installthe freezer near an oven, radiator, or other
heat source where the temperature will rise above 110°F (43° C),
nor in a location where the temperature will fall below 0°F
(-17° C).
Electrical Shock Hazard
Plug into agrounded 3 prong outlet.
Do not remove ground prong.
Do not use an adapter.
Do not use an extension cord.
Failure to follow these instructions can result in
death, fire, or electrical shock.
Explosion Hazard
Keep flammable materials and vapors, such as
gasoline, away from freezer.
Failure to do so can result in death, explosion,
or fire.
Before you move your freezer into its final location, it isimportant
to make sure you have the proper electrical connection. Your
freezer is equipped with a longer power cord for easier placement
and movement.
Recommended grounding method
A115 Volt, 60 Hz., AC only 15 or 20 ampere fused, grounded
electrical supply is required. It is recommended that a separate
circuitserving only your freezer be provided. Use an outlet that
cannot be turned off by aswitch. Do not use an
extension cord.
NOTE: Before performing any type of installation, cleaning, or
removing a light bulb, turn the Freezer control to OFF and then
disconnect the freezer from the electrical source. When you are
finished, reconnect the freezer to the electrical source and reset
the control to the desired setting.
To ensure proper ventilation for your freezer, allow for _/zin. (1.25
cm) space on each side and at the top. When installing your
freezer next to a fixed wall, leave 2 in. (5.08 cm) minimum on
each side (depending on your model) to allow for the door to
swing open.