| Installing Your Cooker |
|
| |
| Fitting the plinth (if applicable) |
| Oven cavity | |
● | Make sure the appliance is raised to a height of 915mm | Door | ||
| or above before beginning. If the appliance is below |
|
| |
| 915mm - you can only fit the plinth cover labelled X. |
|
|
|
| You can adjust the height using the feet (1) of the |
|
|
|
| appliance. |
|
|
|
| If your appliance has a storage drawer at the bottom, |
|
| A |
| you access the required holes through the base of the |
| X (1) | (2) |
| drawer after lifting the mat. | Y | B | (3) |
| Open the appliance doors, and loosen screw A located | |||
|
|
| ||
● |
|
|
| |
| on bracket (2). Do not remove this screw entirely. |
| Plinth cover |
|
● | Insert screw B, through slot (3) and screw into the small |
|
| |
|
|
| ||
| hole at the bottom of bracket (2). |
|
|
|
Make sure that the plinth cover is flush to the appliance |
|
|
| |
| and tighten screw. |
|
|
|
Fitting the splashback (if applicable)
●Remove the screws from the rear of the hotplate vent.
●Locate the splashback in position so that all the fixing holes are in line with the holes in the rear of the hot- plate vent.
●
