Installing Your Cooker
Commissioning - all appliances
G20 | Pressure settings: | |
Natural Gas @ 20mbar | ||
G30 | Butane @ |
|
G31 | Propane @ 37mbar | Hob |
Turn on gas supply and check for soundness at the | ||
hotplate injector. Light two burners and check that the | ||
pressure is correct. | Grill | |
Turn the control knob to the full on position and ignite, | ||
allow the grill to operate for a few minutes. | ||
|
| Oven |
Turn the control knob to the full on position and ignite, | ||
allow the oven to operate for a few minutes |
Connecting to the electricity supply
Mains ignition models only.
Warning - this appliance must be earthed.
The flexible mains lead is supplied connected to a BS 1363 fused plug.
If this plug does not fit in the socket in your home, it should be replaced by a suitable plug as outlined below.
As the colours of the wires in the mains lead of the appliance may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows:
The wire which is green and yellow must be connected to | |
the terminal marked E | (Earth) or coloured green. |
The wire which is coloured blue must be connected to the | |
terminal marked N (Neutral) or coloured black. | |
The wire which is coloured brown must be connected to | |
the terminal marked L | (Live) or coloured red. |
The plug and socket must be accessible after installation.
Should the mains lead ever require replacing, we recom- mend that this is carried out by a qualified electrician who will replace it with a lead of the same size and tempera- ture rating.
Important: ensure that you route all mains, electrical cables and flexible tubing well clear of any adjacent heat source.
E(Earth)
GREEN / YELLOW
N (Neutral) | L (Live) |
BLUE | BROWN |
Use a 3 amp fuse in a 13 amp plug.
The wires in the mains lead are coloured in accordance with the following code:
Green and Yellow = Earth
Blue = Neutral
Brown = Live