3 VALVE ASSEMBLY
Install LOCKNUTS (1) and RUBBER WASHERS (2) onto valve shanks.
Push TUBING (3) ends into VALVE (4) side outlets. Insert VALVES (4) into mounting holes from underside of ledge.
Press TEE (5) onto SPOUT SHANK (6) making certain that the
Thread of VALVE BODY (4) should extend at least 5/16 inch above MOUNTING SURFACE (11). If necessary, adjust LOCKNUT (1).
9
10
11MOUNTING
SURFACE
9
Place RUBBER RING (10) into ESCUTCHEON ADAPTERS (9) and thread onto |
|
valves until snug against internal stop. | 10 |
Tighten LOCKNUT (1) with WRENCH supplied to secure VALVE (4) position.
Slide FERRULE (12) and COUPLING NUT (13) to outlet of VALVE (4) and tighten COUPLING NUT (13) firmly.
Connect HOT water supply to inlet of left VALVE and COLD water supply to inlet of right VALVE using appropriate connector.
9
10 | HOT |
4
|
| 7 |
12 | 13 | 6 |
| ||
|
|
5/16'' MIN. | 4 | 11 |
2
Wrench
1
MOUNTING | 3 | 12 | 4 |
|
| ||
|
|
| |
SURFACE |
| 5 |
|
|
|
| |
8a |
| 8 |
|
|
| 13 | COLD |
4 INSTALL HANDLES |
|
|
|
Push ADAPTER (1) on VALVE STEM (2). See figure "A". Tighten |
|
|
|
STEM SCREW (3) to secure ADAPTER (1). |
|
| THREAD ON |
|
|
| TO DECK |
Find correct position of LEVER HANDLE ASSEMBLY (4) by adjusting |
| 4 | ADAPTER |
|
| ||
male teeth on ADAPTER (1) to female teeth in HANDLE (4). | SPLINE |
|
|
|
| TOP | |
Thread LEVER HANDLE ASSEMBLY (4) onto DECK ADAPTER (5) | END UP |
| |
|
| ||
|
|
| |
until snug against mounting surface. |
|
| 1 |
| Figure "A" |
| 3 |
|
| 2 | |
|
|
|
5
5 SERVICE
To change direction of handle rotation, proceed as follows:
Turn valve to OFF position.
Thread
Use a flat blade screw driver to remove SPRING CLIP (4).1 2
Lift STOP WASHER (5), turn 90˚ and replace.
Replace SPRING CLIP (4). Reinstall HANDLE ASSEMBLY (2).
If spout drips, operate handles several times from OFF to ON position. Do not force - handles turn only 90˚.
VALVE
5 | 90˚ |
|
4
3
M968830 Rev . 1 . 4