SERIN2064.90X | American Standard

Installation

Instructions

SERIN™2064.90X

DECK MOUNT BATH FILLER

Thank you for selecting American-Standard...the benchmark of ﬁne quality for over 100 years.

To ensure that your installation proceeds smoothly-- please read these instructions carefully before you begin.

Certiﬁed to comply with ANSI A112.18.1M

M968830 Rev . 1 . 4

To ensure that your installation proceeds smoothly-please read these instructions carefully before you begin.

Recommended Tools

Flat Blade Screwdriver

	Tubing Cutter
Adjustable Wrench	*Wrench
	*Wrench
Channel Locks	*Hex key
	*Supplied with Fitting

ROUGHING-IN DIMENSIONS

6-1/2" to 12"

(165mm to 305mm)

				2" D.
			3-1/4" D.	(52mm) D.
			3-1/4" D.
9-1/2"	9-3/4"		(82mm) D.
9-1/2"	9-3/4"
(240mm)	(247mm)	2-3/4"
	6-3/4"	(71mm)
	6-3/4"
	(170mm)				2-1/16" D.
MOUNTING					(52mm) D.
MOUNTING
SURFACE
		1-1/8 D.		3'
				3'
				(76mm)	1-1/2 MAX.
	1-3/16" MAX.				1-1/2 MAX.
	1-3/16" MAX.				(38mm) MAX.
	(30mm) MAX.				(38mm) MAX.
	(30mm) MAX.
					1-3/16 D.
			(H)	(C)	(30mm) D.
			(H)	(C)
	3/4-14 MALE		1-1/16 D.	12 MAX.
	N.P.T. INLETS		1-1/16 D.	(305mm)
	N.P.T. INLETS		(27mm) D.	(305mm)
			(27mm) D.

1			Turn off hot and cold water
	SPOUT ASSEMBLY	CAUTION
			supplies before beginning.

Install RUBBER RING (1) into ESCUTCHEON RING (2) and place over mounting hole.

Insert SPOUT SHANK (3) through center hole of MOUNTING LEDGE. Make sure that the RUBBER RING (1) is properly seated in RECESS

of ESCUTCHEON RING (2).

Assemble RUBBER WASHER (4) and BRASS WASHER (5) onto SHANK (3). From underside of ledge secure SPOUT (7) into position with LOCKNUT (6).

2 PREPARE TUBE AND TEE ASSEMBLY

Prepare TUBE and TEE ASSEMBLY (1) to ﬁt center to center VALVE (2) location (between 6-1/2" and 12"). If necessary, cut and/or bend TUBING carefully. Make sure tube bend is close to the TEE (1) so that it will not effect the compression joint at the VALVE CONNECTION.

Remove COUPLING NUT (3) and FERRULE (4) from each VALVE (2) and slide onto TUBING (5).