Timer Operation
Installing your hob
Your hob has a timer built in which can either be used to automatically switch off a cooking zone after a pre set period of time, or as an alarm reminder. The timer features a maximum duration of 99 minutes.
Automatic cook stop 1. | Touch pad , on the timer controller, by the |
| symbol. A ‘t’ will appear in each hotplate control display. |
2.Select the hotplate to be timed using the 
pad, and set to the desired energy level.
3.Set the timer to the desired duration. Once the time period has elapsed the element will switch off and an alarm will sound. The alarm can be stopped by pressing any touch pad.
4.To cancel a countdown duration, either reduce the time
|
| period to ‘0’ using the | pad, or press both | and |
|
| pads simultaneously. |
|
|
Alarm | 1. | Set required energy level for elements required. |
| |
2.Touch pad 
, on the timer controller, indicated by 
symbol until the time duration required is reached.
A ‘t’ will appear in each hotplate control display. For Alarm only, it is not necessary to select a hotplate. After 10 seconds the controller will beep and the displays will revert to showing energy level.
The alarm will sound once the time has elapsed, and can be stopped by pressing any of the touch pads.
3.To cancel an alarm duration, either reduce the time period
to ‘0’ using the 
pad, or press both 
and 
pads simultaneously.
Belling built-under single oven unit or double oven unit
The hob can be fitted above a Belling
For your own safety, we recommend that your hob and oven are connected by a competent electrician. The installation must comply with current I.E.E. Wiring Regulations.
Follow the installation instructions supplied with the oven unit. To make sure that there is adequate clearance between the top of the oven unit and the underside of the hob, the oven support shelf must be at least 615mm or 705mm from the underside of the worktop, depending on the type of oven being fitted, shown in the diagram below. Fit an infill piece along the underside front edge of the work top to form the top of the oven cavity where required.
Fit the hob before mounting the oven in its cavity, making sure that the cables are looped well to the back.
14 | 7 |
