Global Machinery Company BJ600 Making a corner joint, Making a T-joint, Maintenance, Cleaning

8.When all slots have been cut, clean the edge and slots of any remaining sawdust.

9.Place the biscuits into position and fit the matching timber pieces together.

10.Clamp the boards and wipe clean any excess glue and leave to set as per the glues specifications.

Making a corner joint

3.	Cut the slots into the workpiece that will become the
	vertical board.
4.	Cut the slots into the workpiece that will become the
	horizontal board
5.	Once all the slots are cut insert a biscuit into each joint
	and dry assemble the workpieces to ensure everything
	lines up and fits.
6.	Insert a water-based glue into the slots.

1.Set the 2 pieces together and draw the joint centres on the outside face and end.

2.Cut the slots into the end piece.

Centreline mark(s)

slot Biscuit

7.	When all slots have been cut, clean the edge and slots of
	any remaining sawdust.
8.	Place the biscuits into position and fit the matching timber
	pieces together.

3. Cut the slots in the face piece.

4.Once all the slots are cut insert a biscuit into each joint

and dry assemble the workpieces to ensure everything lines up and fits.

5.Insert a water-based glue into the slots.

6.When all slots have been cut, clean the edge and slots of any remaining sawdust.

7.Place the biscuits into position and fit the matching timber pieces together.

8.Clamp the boards and wipe clean any excess glue and leave to set as per the glues specifications.

Making a T-joint

1.Place the 2 pieces to be joined on a level bench.

2.Mark the centreline for each biscuit.

Clamp.

To cut end slots in

9. Clamp the boards and wipe clean any excess glue and

leave to set as per the glues specifications.

Maintenance

All the bearings are sealed ball bearings, lubricated for life, and require no maintenance.

Regularly check that all the fixing screws are tight. They may vibrate loose over time.

Power cord maintenance

If the supply cord needs replacing, the task must be carried out by the manufacturer, the manufacturer’s agent, or an authorised service centre in order to avoid a safety hazard.

Cleaning

1.Keep the tool’s air vents unclogged and clean at all times.

2.Remove dust and dirt regularly. Cleaning is best done with a rag. Wear safety goggles or an eye shield and gloves whist cleaning.

3.Keep all moving parts free of built up sawdust and other foreign matter.

4.Never use caustic agents to clean plastic parts.

CAUTION. Do not use cleaning agents to clean the plastic parts of the tool. A mild detergent on a damp cloth is recommended. Water must never come into contact with the tool.

13