Fitting and removing the battery pack
To remove the battery pack from the blower firmly press the battery release tabs (4) at either side of the battery pack, and slide the battery backward out of the tool.
To install the battery pack, align rails, on the tool with the tabs on the battery pack and slide the battery pack on to the blower. Ensure the battery pack is sitting straight on the foot and correctly entering the runners. The battery should slide fully on to the drill foot until the battery pack “clicks” into position.
Battery charging | a | b |
1.Connect charger (5) to power source. The green light (a), should light up. This indicates the charger is ready to begin charging.
2.Position battery pack on charger, align rails (d), on battery charger with (e) on battery pack. Slide battery forward onto charger until it clicks into position.
3.The red light (b), should
begin to glow continuously, |
| d | |
indicating that the battery |
| ||
|
| ||
|
|
|
|
| e |
|
|
|
|
|
|
pack is receiving a “Fast Charge”.
4.After approximately one hour, the “Fast Charge” indicator red light (b) should go out indicating that the battery pack is fully charged and that the charger is now in a “Maintenance Charge”
mode, this is confirmed by the light (a) coming back on. The battery pack can be left on “Maintenance Charge” until you are ready to use it, however it is not recommended to leave the battery on charge for longer that 24 hours.
5.To remove the battery pack from the charger depress the battery pack release tabs (4) and slide the battery off.
WARNING. Do not leave batteries charging for longer than 24 hours. Note. Depending on room temperature, line voltage, and existing charge level, initial battery charging may take longer than one hour.
NOTE. Disconnect charger from power source when not in use.
To obtain the best life for the battery
•Never allow the drill to come to a complete stand still before recharging. The battery should be placed on charge whenever the battery is noticeably running down or the drill no longer performs a task it previously performed.
•Avoid conducting short charges. Make sure that the battery is fully charged every time by allowing the charger to complete its full charging cycle.
•Avoid allowing lose items like screws or nails etc to be stored with battery packs as these or similar items can short battery packs and cause a fire or explosion.
•Always unplug the charger when not in use and store in a dry secure place.
•Avoid charging or storing your battery in temperatures below 0ºC and above 40ºC.
9
