![](/images/new-backgrounds/1210077/21007721x1.webp)
To obtain the best life for the tool
The screwdriver should be placed on charge whenever the chuck/bit retainer (1) no longer turns. DO NOT continue to use the screwdriver when the charge is exhausted. The screwdriver does not have automatic spindle lock and using the screwdriver with no charge may damage the tool.
During operation avoid overloading the screwdriver. Doing so will allow you to maximise the charge run time.
Avoid allowing loose items like screws or nails etc. to be stored with tool as these or similar items can short battery packs and cause a fire or explosion.
Always unplug the charger when not in use and store in a dry secure place.
Using the screwdriver
Direction of Rotation/Forward and Reverse
The screwdriver has a
or reverse. To operate the screwdriver in the forward direction, depress the top half (forward arrow) of the switch (2). To operate the screwdriver in reverse, depress the bottom half (reverse arrow) of the switch (2). To stop the screwdriver, release the switch and allow the motor to come to a complete stop.
Inserting and removing bits
1.Select an appropriate bit and Insert it into the hexagonal hole in the chuck/bit retainer (1). The screwdriver is now ready for use.
2.To remove the screwdriver bit you simply remove the existing bit by pulling the bit out of the chuck/bit retainer (1).
Maintenance
•Store the tools, instruction manual and where necessary the accessories in the original packaging. In this way you will always have all the information and parts on hand.
•If the cordset of the charger is damaged or worn, have it repaired or replaced by an authorised service centre in order to avoid a hazard.
•Service to the tool should only be performed by qualified repair persons using identical replacement parts. This will ensure the safety of the power tool.
11