Always unplug the charger when not in use and store in a dry secure place.
Avoid charging or storing your battery in temperatures below 0ºC and above 40ºC.
Battery indicator
To activate the battery indicator feature first pull the trigger switch (3) then press the battery indicator button (11), this will display the level of charge remaining in the battery. There are 3 levels of charge low, medium and high. When the battery indicator is showing only 1 LED (low) the battery should be removed and put on the charger.
LED Work area light
The drill has 3 LED lights (10) to illuminate the work area and improve vision when drilling in areas with insufficient light.
To turn the LED lights on and off depress the LED light switch (12).
Using the drill
Use the forward/reverse switch (4) to select the direction of rotation, then pull the trigger (3). This trigger switch is an electronic variable speed control which enables the user to vary the speed continuously. The speed varies according to how far the trigger switch is depressed, the further it is depressed the faster the chuck will rotate and the lighter it is depressed, the slower it will rotate.
To stop the drill, release the trigger switch.
Note. You can only change the direction of rotation of the drill using the forward/reverse switch when the trigger is NOT depressed.
Forward/reverse switch
This switch (4) will allow you to change the direction of
the motor while the trigger switch is not depressed.
Drilling uses the forward mode. The reverse mode is intended for the removal of screws.
Adjustable torque
This drill is equipped with 20 torque settings plus one drill setting which are controlled by the torque collar (2). By rotating the collar behind the chuck, it is possible to adjust the torque.
This will allow better control when using the drill as a screwdriver as it prevents
For drilling, always use the use the Drill position by aligning the Drill symbol with the triangular indicator on the front face of the drill near the torque collar.
For setting the torque position, select a low setting on the torque collar and align the selected symbol with the triangular indicator on the top of the drill. Increase gradually to set the correct torque. It is better to use a scrap piece of material if possible to set the torque.
10
