Making a cut
1.Mark the line of cut on the workpiece and align the blade guide as follows:
a. Cutting at 90° |
| b. Cutting at 45° | |
|
|
|
|
|
|
|
|
2.Rest the front edge of the base on the workpiece. Start the motor and let the blade reach full speed (approximately 2 seconds).
3.Slowly push the saw forward using both hands.
Note. When making a cut always
use steady, even pressure. Forcing the saw causes rough cuts and could shorten the life of the saw or cause kickback. Allow the blade and the saw to do the work.
4.After completing your cut, release the switch (4) and allow the blade to come to a complete stop. Do not remove the saw from the workpiece while the blade is moving.
Note. Since blade thickness varies, always make a trial cut in scrap material along the guideline to check the accuracy of the blade guide notches.
Making a pocket cut
1.Adjust the depth of cut as required.
2.Adjust the bevel setting to 0°.
3.Raise the lower blade guard lever (13) to expose the saw blade, firmly rest the front of the base flat against the workpiece with the rear handle raised so the blade does not touch the workpiece.
4.With the blade just clearing
the workpiece, start the motor by depressing the
5.Always let the blade reach full speed (approximately 2 seconds) before you begin to cut into the workpiece.
6.Slowly lower the saw into the workpiece, using the front of the base resting on the workpiece as a hinge point.
WARNING. As soon as the blade starts cutting the material, release the lower blade guard
lever.
7.Once the base plate (15) is flat against the workpiece, proceed cutting in a forward direction to the
end of the cut.
8.After completing your cut, release the trigger switch and allow the blade to come
to a complete stop. Do not remove the saw from the workpiece while the blade is moving.
Note. If the corners of your pocket cut are not completely cut through, use a jigsaw or hand saw to finish the corners.
10
