Cleaning
1.Keep the tool’s air vents unclogged and clean at all times.
2.Remove dust and dirt regularly. Cleaning is best done with a rag.
3.
4.If the body of the saw needs cleaning, wipe it with a soft damp cloth. A mild detergent can be used but nothing like alcohol, petrol or other cleaning agent.
5.Never use caustic agents to clean plastic parts.
CAUTION. Do not use cleaning agents to clean the plastic parts of the tool. A mild detergent on a damp cloth is recommended. Water must never come into contact with the tool.
General inspection
Regularly check that all the fixing screws are tight. They may vibrate loose over time.
Power cord maintenance
If the supply cord needs replacing, the task must be carried out by the manufacturer, the manufacturer’s agent, or an authorised service centre in order to avoid a safety hazard.
Troubleshooting
Trouble | Problem | Suggested remedy | |
|
|
| |
Saw will not start | Power cord not plugged in | Ensure that the cord is connected to the power supply | |
|
|
| |
| Power fault, fuse or circuit breaker | Check the power supply | |
| tripped |
| |
|
|
| |
| Cord damaged | Use authorised service centre to repair or replace | |
|
|
| |
| Burned out switch | Use authorised service centre to repair or replace | |
|
|
| |
| Faulty motor | Use authorised service centre to repair or replace the | |
|
| motor | |
|
|
| |
Blade does not reach | Extension cord too long or undersized | Use extension cord heavy enough to carry the current | |
full speed |
|
| |
Tool is overheating | Turn off the tool and let it cool down to room temperature. | ||
| |||
|
| Inspect and clean the ventilation slots | |
|
|
| |
Poor cutting | Accessory blunted | Replace with new circular saw blade | |
|
|
| |
Vibration or abnormal | Loose parts | Check to see that all knobs and levers are securely | |
noise |
| tightened including bevel adjustment knob, depth locking | |
|
| lever and parallel fence locking knob | |
|
|
| |
| Blade vibrating | Ensure that the blade nut is securely tightened | |
|
|
| |
| Moving parts excessively worn | Use authorised service centre to repair or replace | |
|
|
|
13
