6.Start the motor by depressing the
7.Always let the blade reach full speed (approximately
2 seconds) before you begin to cut into the work piece.
8.Slowly push the saw forward using both hands, keeping the red laser light beam on the line of cut.
9.After completing your cut, release the trigger switch and allow the blade to come to a complete stop.
Do not remove the saw from the work piece while the blade is moving.
10.Switch off the laser beam on completion of the cut.
Note. The laser generated line is preset to align with the left side of the blade (closest to the motor).
Changing the blade
CAUTION. Always ensure that the saw is switched off and unplugged from the power supply before making any adjustments.
1.Place saw on its side on a flat surface.
2.Rotate the saw blade by hand whilst depressing the spindle lock button (20) until the blade locks (Fig. Q).
3.Whilst depressing the spindle lock button, turn the blade bolt
Q |
| R |
|
|
|
4.Remove the outer blade flange and the blade bolt.
5.Raise the lower blade guard (14) using the blade guard lever (13).
6. Remove the saw blade
from the inner flangeS and pull it out (Fig. S)
7.Clean the saw blade flanges thoroughly before mounting the new saw blade. Wipe a drop of oil onto the inner and
outer flange where they |
|
will touch the blade. | T |
8.Mount the new saw blade onto the spindle and against the inner flange.
9.Replace the outer flange and tighten the blade bolt (Fig. T).
WARNING. The direction in which the blade rotates has to be the same as the direction
of the arrow marked on the housing (25).
10.Ensure that the spindle lock button (20) is released.
11.Before using the saw again, check that the safety devices are in good working order.
IMPORTANT. After replacing the saw blade, make sure that the saw blade runs freely by turning the blade by hand.
12.Plug the machine into a power socket and run the saw under no load to check that it runs smoothly before using it to cut any material.
12
