tool with your finger on the switch.
17.Use outdoor rated extension cords. When a tool is used outdoors, use only extension cords that are intended for outdoor use and are so marked.
18.Stay alert. Watch what you are doing. Use common sense. Do not operate a power tool when you are tired.
19.Check for damaged parts. Before using a tool, check that there are no damaged parts. If a part is slightly damaged, carefully determine if it will operate properly and perform its intended function. Check for alignment of moving parts, binding of moving parts, breakage of parts, proper mounting and any other conditions that may affect the operation of the tool. A part that is damaged should be properly repaired or replaced by an authorised service facility, unless otherwise indicated in this Instruction Manual. Defective switches must be replaced by an authorised service facility. Do not use a tool if the switch does not turn the tool on and off correctly.
20.Guard against electric shock. Prevent body contact with grounded objects such as water pipes, radiators, cookers and refrigerator enclosures.
21.Use only approved parts. When servicing, use only identical replacement parts. Use an authorised service facility to fit replacement parts.
WARNING. The use of an accessory or attachment, other than those recommended in this Instruction Manual, may present a risk of personal injury.
Additional safety rules for electric routers
•Remove the plug from the socket before carrying out any adjustment, servicing or maintenance.
•Fully unwind cable drum extensions to avoid potential overheating.
•When an extension cable is required, you must ensure it has the right ampere rating for your power tool and is in a safe electrical condition.
•Ensure your mains supply voltage is the same as your tool rating plate voltage.
•Your tool is double insulated for additional protection against a possible electrical insulation failure within the tool.
•Always check walls, floors and ceilings to avoid hidden power cables and pipes.
•After long working periods external metal parts and accessories could be hot.
•Always wear eye and ear protection and use a dust mask.
•Handle router bits with care, they can be extremely sharp.
•Check the bit carefully for signs of damage or cracks before use. Replace cracked or damaged bits immediately.
•Remove all nails, screws and other objects from the workpiece. You can damage the bit and the tool by cutting into a nail or other metal. It can also present a safety hazard.
•Always use both handles and make sure that you have a good grip on the router before proceeding with any work.
•Keep your hands away from the rotating bit.
•Make sure that the bit is not in contact with the workpiece when you switch the machine on.
•Before using the tool to make a cut, switch on and let it run for a while. Watch for vibration or wobbling that could indicate an improperly installed bit.
•Take notice of the direction of rotation of the bit and the direction of feed.
•Do not leave the machine running unattended. Operate the tool only when controlled by both hands.
•Always switch off and wait until the bit has come to a complete standstill before removing the machine from the workpiece.
5
