Operation
Switching on and off
1.Connect the plug to the power supply.
2.Depress the ON button.
3.To switch off, depress the OFF button.
NOTE.
1.The saw must be connected to an earthed outlet and should be operated on a residual current device (RCD) of 30 mA capacity.
2.Extension leads must have a minimum lead cross section of 3 x 0.75 mm (240V).
3.The saw is automatically turned off in the event of a power failure. You will need to press the ON button again to restart the saw (only on some models).
Using the rip fence
The rip fence allows you to make parallel cuts in a sheet of wood, all at the same width.
WARNING. Always ensure that the saw is switched off and unplugged from the power supply before making any adjustments.
1.Adjust the rip fence to the required width and secure it in position with the locking handle.
2.Ensure that the fence rests against the wood along its entire length to give a consistent parallel cut.
Cutting
NOTES.
1.Use only enough pressure to keep the saw cutting. Do not force the cutting.
Allow the blade and the saw to do the work.
2.When cutting at an angle ensure that the rip fence is located on the right hand side of the blade.
3.When cutting rod, use a jig or fixture to prevent the workpiece from turning.
4.When cutting boards vertically, use a suitable push block to feed the workpiece into the saw.
Maintenance
Cleaning
Note. Always wear eye protection when cleaning the tool.
1.Keep the tool’s air vents unclogged and clean at all times.
2.Remove dust and dirt regularly. Cleaning is best done with compressed air or a rag.
3.
4.Never use caustic agents to clean plastic parts.
CAUTION. Do not use cleaning agents to clean the plastic parts of the saw. A mild detergent on a damp cloth is recommended. Water must never come into contact with the saw.
General inspection
1.Regularly check that all the fixing screws are tight. They may vibrate loose over time.
Repairs
Call GMC on 1300 880 001
We can advise you as to the best method to repair your tool.
Please do not return the tool to the store where you purchased it without first contacting GMC.
10
