Accessories
The SG18V is supplied with:
•2 x 18V Battery packs
•Bit holder
(with nose cone)
We recommend that you purchase you accessories in the
store from where you obtained the tool. Use good quality accessories and the brand recommended by the vendor. Sales staff will help and offer advice.
Installing and removing the battery pack
Always switch off the tool before inserting or removing a battery pack.
To remove the battery pack (8), press the release buttons (9) on each side of the battery pack and withdraw the pack from the tool.
To insert the pack, align the
tongue on the pack with the groove in the housing and push it into the tool. Make sure that it “clicks” into its final position so that it is safely locked in place.
Battery charging
The battery pack for this tool has been shipped in a low charge condition. You should charge the battery pack fully before use.
WARNING. Do not use an extension cord.
WARNING. Do not throw used batteries into a fire or water: it could cause an explosion!
Please hand in
Before inserting into or removing the battery pack (8) from the charger (10) always ensure that the plug is not in the mains socket.
Slide the battery on to the
charger with the rails of thed battery pack (e) aligned with the
rails of the charger (d). Slide the
battery down until it “clicks” into position.
e
The red light on the charger should begin to glow continuously, indicating that the battery pack is receiving a “Fast Charge”.
After approximately one hour, the “Fast Charge” indicator light (red) should go out and the green light
should be lit, indicating that the battery pack is fully charged.
Note. It is necessary to depress both battery pack release buttons (9) in order to remove the battery pack from the charger.
Depending on room temperature, line voltage, and existing charge level, the initial battery charging may take longer than one hour.
Disconnect the charger from the power source when it is not in use.
9
