6.Always let the blade reach full speed (approximately
2 seconds) before you begin to cut into the workpiece.
7.Slowly lower the saw into the workpiece, using the front of the base resting on the workpiece as a hinge point.
WARNING. As soon as the blade starts cutting the material, release the lower blade guard lever (23).
8.Once the base plate (12) is flat against the workpiece, proceed cutting in a forward direction to the end of the cut.
9.After completing your cut, release the trigger switch (2) and allow the blade to come to a complete stop. Do not remove the saw from the workpiece while the blade is moving.
Note. If the corners of your plunge cut are not completely cut through, use a jigsaw or hack saw (with a masonry cutting blade) to finish the corners.
Using the parallel fence | Z |
|
The parallel fence (11) allows you to make parallel cuts in a tile, all at the same width.
CAUTION. Always ensure that the saw is switched off and unplugged from the power supply
before makinga any adjustments.
1.Loosen the parallel fence locking knob (10) (Fig. Z).
2.Slide the parallel fence (11) through the slots in the base plate (27) (Fig. a).
3. Adjust the parallel fence to the | b | |
required width and secure it in | ||
| ||
position with the parallel fence |
| |
locking knob (10). |
|
4.Ensure that the parallel fence rests against the tile along its entire length to give a consistent parallel cut (Fig. b).
Fitting the dust extraction adaptor |
| ||
IMPORTANT. Always remove the water cooling system |
| ||
before cutting timber. |
|
| |
| c | ||
IMPORTANT. Always remove and |
| ||
|
| ||
clean the port of debris after use. |
|
| |
1. Remove the water system port |
|
| |
plug (21) by removing the fixing |
|
| |
screw (Fig. c) and sliding it from |
|
| |
the dust extraction port. |
|
| |
Note. Use a flat headed |
|
| |
|
| ||
| d | ||
screwdriver at the front center of |
| ||
the water system port plug and |
|
| |
lever outwards (Fig. d). |
|
| |
2. Fit the dust extraction adaptor |
|
| |
(32) into the dust extraction port |
|
| |
(Fig. e). |
|
| |
3. Slide the fixing screw through |
|
| |
the inlet on the adaptor (32) |
|
|
|
|
| e | |
and onto the bracket of the saw. |
|
| |
|
|
| |
Ensure this is tight (Fig. f). |
|
|
|
Maintenance |
|
|
|
WARNING. Always ensure that the |
|
|
|
tool is switched off and the plug |
|
|
|
is removed from the power point |
|
|
|
before making any adjustments or |
|
|
|
|
| f | |
maintenance procedures. | |||
Always wear sturdy gloves when |
| ||
handling or changing blades as |
| ||
they can be very sharp. |
| ||
1.Keep the tool’s air vents unclogged and clean at all times.
2.Regularly check to see if any dust or foreign matter has entered the grills near the motor and around the trigger switch. Use a soft brush to remove any accumulated dust. Wear safety glasses to protect your eyes whilst cleaning.
15
