Unpacking
Due to modern mass production techniques, it is unlikely that your power tool is faulty or that a part is missing. If you find anything wrong, do not operate the tool until the parts have been replaced or the fault has been rectified. Failure to do so could result in serious personal injury.
Fitting the collection bag
Prior to fitting the collection
bag, the blow/vac tube must A be fitted to the housing.
1. Attach the strap on the |
| ||
collection bag to the hook |
| ||
underneath the blow/vac |
| ||
tube (fig A). |
| ||
2. Attach the plastic |
| ||
connector to the outlet |
|
| |
|
| ||
in the housing, ensuring |
| ||
B | |||
that the latch at the back | |||
‘clicks’ into position |
| ||
(fig B). |
| ||
To remove the collection bag, |
| ||
disconnect the attachments |
| ||
in the reverse order. |
| ||
|
|
| |
Fitting the auxiliary handle
For full control of the blower vac the auxiliary handle should always be fitted and adjusted to the most suitable position for the operator.
1.To fit the handle to the housing, fully unscrew and remove the adjusting knob and bolt from the auxiliary handle.
2.Slide the auxiliary handle over the housing, ensuring handle is orientated so as the serrated or pattern surface aligns with the same pattern surface on the housing.
3.Fit the auxiliary locking
bolt through the handle A
and housing from the left hand side of the blower vac (same side as the blower vacuum selector) and tighten in a clockwise direction (fig A).
4.To adjust the angle of the handle, loosen the auxiliary
locking knob (rotate in an
Fitting the patio head
The patio head can be easily fitted or removed from the blow/vac tube.
1. Hold the blower/vac upside | A | |
down so you are looking | ||
| ||
down into the blow/vac |
| |
tube. |
|
2.Ensure the patio head is the correct way up, with the oval indentation facing down. (fig A)
3.Firmly press the patio head into the blow/vac tube till it click’s into position.
8
