Avenger Owner’s Manual

Revised 06/04/08

CARE AND MAINTENANCE

This is the “LED” light that will flash in the event of a problem.

Main Circuit Breaker

The 50-amp circuit breaker and exposed reset button

AreA located under the battery cover. The button is visable through the battery cover. If your Avengerfails to operate, your main circuit breaker may have tripped.

WARNING: DO NOT ATTEMPT ELECTRICAL

REPAIRS. CONSULT GOLDEN TECHNOLOGIES

OR YOUR AUTHORIZED GOLDEN DEALER.

Possible causes for the main circuit breaker to trip:

“Run-down” batteries.

Over exerting the motor.

Circuit Breaker

Found on the rear of the unit next to the freewheel brake release.

Possible solutions:

Recharge your batteries.

If the problem persists, have an authorized Golden dealer “load test” the batteries to assure they are not damaged.

If the problem persists, assure your battery charger is operating properly.

Resetting the Main Circuit Breaker

If the main circuit breaker trips as a result of “run-down” batteries or because of a temporary overload, reset the circuit breaker using the following directions:

1.Wait 5 minutes to allow the motor and electronics board to cool, or return to “normal” operating temperature.

2.Press in on the main circuit breaker reset button.

WARNING: BE SURE YOU REMOVE THE KEY FROM THE KEY RECEPTACLE BEFORE RESETTING YOUR SCOOTER.

Page 29
Image 29
Golden Technologies GA 531, GA 541 owner manual Care and Maintenance