Gold's Gym GACR02 manual Assembly, Nylon Locknut yet, Nylon Locknuts yet. Press two 50mm

Assembly

Assembly requires two persons. Place all parts of the CORNER BOXING RACK in a cleared area and remove the packing materials. Do not dispose of the packing materials until assembly is completed. Assembly requires two adjustable wrenches (not included).

M6 Nylon		M10 Nylon	M10 Washer
Locknut (25)–6		Locknut (23)–17
			(21)–17
M6 x 30mm Bolt (24)–6	M10 x 35mm Carriage Bolt (22)–4		M10 x 63mm Carriage Bolt (27)–2
M10 x 70mm Bolt (18)–5			M10 x 65mm Bolt (20)–4
			M10 x 95mm Bolt (26)–1
M10 x 15mm Screw (16)–8

1. Press a Large Plastic Cap (15) into the lower	1
end of the Lower Frame (2). Press a 50mm
Square Plastic Cap (14) into each Base (5, 6).
Hold the Left and Right Bases (5, 6) against the
Lower Frame (2) as shown. Attach the Bases to					2
the Lower Frame with an M10 x 70mm Bolt (18)
and an M10 Nylon Locknut (23). Do not tighten
the Nylon Locknut yet.
See the inset drawing. The CORNER BOXING					23
	14
RACK is designed to be placed in the corner of			5
a room. If you do not plan to use the CORNER						18
BOXING RACK in a corner, the Rear Base (19)
should be attached. Position the Rear Base
against the Lower Frame (2) as shown. Attach		14	2
the Rear Base to the Lower Frame with the M10
	5	18	26
x 95mm Bolt (26), an M10 Washer (21), and an				19	15	6
M10 Nylon Locknut (23). Do not tighten the
Nylon Locknut yet. Next, attach the Rear Base
to the Left and Right Bases (5, 6) with two M10	21		18	14
x 70mm Bolts (18), two M10 Washers (21), and		21
two M10 Nylon Locknuts (23). Do not tighten		23				14
the Nylon Locknuts yet. Press two 50mm		21	6
Square Plastic Caps (14) into the Rear Base.
	5