2.Press two Base Feet (18) onto a Base (3) as shown.
Attach a Support Upright (7) to the Base (3) with two M8 x 50mm Bolts (48), two M8 Washers (34), and two M8 Nylon Locknuts (35). Do not tighten the Locknuts yet.
Assemble the other Base (3) and Support Upright (7) in the same manner.
Set the Uprights (8) on the Bases (3) as shown. Attach an Upright to a Base with two M10 x 95mm Bolts (40), an Upright Joint Plate (19), and two M10 Nylon Locknuts (37). Attach the other
Upright and Base in the same manner. Do not tighten the Locknuts yet.
Attach an Upright (8) to a Support Upright (7) with four M10 x 95mm Bolts (40), two Upright Support Plates (20), and four M10 Nylon Locknuts (37).
Do not tighten the Locknuts yet.
Attach the other Upright (8) to the other Support Upright (7) in the same manner.
3.Press a 50mm Square Inner Cap (27) into the top of the Front Leg (4). Press the Front Leg Foot (17) onto the bottom of the Front Leg, as shown.
Attach the Front Leg (4) to the Bench Frame (1) with four M10 x 68mm Bolts (41), two Front Leg Plates (21), and four M10 Nylon Locknuts (37).
Do not tighten the Locknuts yet.
4.Attach the Bench Frame (1) to the Crossbar (2) with two M10 x 95mm Bolts (40) and two M10 Nylon Locknuts (37).
Tighten M10 Nylon Locknuts (37) and M8 Nylon Locknuts (35) used in steps
2 |
|
|
| 8 |
|
40 |
|
|
|
| 8 |
|
| 7 |
| 20 | 48 |
| 48 | |
|
| |
40 | 19 | 7 |
|
| |
| 37 | 37 |
|
| |
|
| 20 |
| 37 |
|
3 |
|
|
|
| Tall |
|
| Side |
Tall | 34 | 3 |
| ||
Side | 35 | 18 |
| 18 | 18 |
|
| |
3 |
| 1 |
37 |
| |
|
| |
27 |
|
|
| 21 |
|
| 4 | 41 |
|
| |
Tall |
|
|
Side |
|
|
| 17 |
|
4 |
|
|
| 40 | 2 |
|
| |
| 1 |
|
| 37 |
|
6
