The lower left corner of the display can show the elapsed time, the distance that you have walked or run during your workout, and the
incline level of the treadmill. Note: During a classic workout, the display will show the time remaining in the program instead of the elapsed time.
The lower right cor- ner of the display can show the speed of the walking belt and the approximate number of calories that you have
burned during your workout. The lower right corner of the display will also show your heart rate when you use the handgrip pulse sensor.
The upper left corner can show the elapsed time, the speed of the walking belt, the ap- proximate number of calories that you have
burned, and the distance that you have walked or run. Press the Display button repeatedly until the upper display shows the information that you are most interested in viewing.
While information is shown in the upper left corner of the display, the same information will not be shown in the lower left or lower right display.
To reset the display, press the Stop button, remove the key, and then reinsert the key.
6.Measure your heart rate if desired.
Before using the handgrip pulse sensor, remove the sheets of clear plastic from the metal contacts. In addition, make sure that your hands are clean.
To measure your heart rate, stand on the foot rails and place your hands on the metal contacts— avoid moving your hands. When your pulse is detected, the
heart symbol in the display will begin to flash each time your heart beats, one or two dashes will ap- pear, and then your heart rate will be shown. For the most accurate heart rate reading, continue to hold the contacts for about 15 seconds.
7.Turn on the fan if desired.
The fan features low and high speed settings. Press the Fan button repeatedly to select a fan speed or to turn off the fan. Note: If the fan is on when the walking belt is stopped, the fan will turn off automatically after a few minutes.
8.When you are finished exercising, remove the key from the console.
Step onto the foot rails, press the Stop button, and adjust the incline of the treadmill to the lowest setting. The incline must be at the lowest setting when you fold the treadmill to the storage posi- tion, or you may damage the treadmill. Next, re- move the key from the console and put it in a secure place.
When you are finished using the treadmill, switch the reset/off circuit breaker to the “off” position and unplug the power cord. IMPORTANT: If you do not do this, the treadmillʼs electrical compo- nents may wear prematurely.
14
